BGS technic 9086 Manuel D'instructions page 9

DISASSAMBLING
Pull out the worn out wheel hub/bearing unit with the spindle and the spindle nut.
ASSEMBLING
ATTENTION: be cleaned before installation of the new wheel hub/bearing unit, the contact surface
in the wheel bearing housing.
Mount the mounting shells to the new wheel hub/bearing unit with the fastening bolts for the
mounting shells.
Lay the new hub/bearing unit onto the mounting plate so that the pre-assembled bolts touch the
mounting shells through the wheel stud holes.
Attach the mounting plate sideways to the drive shaft and lead the spindle with the attached
mounting plate and new hub/bearing unit from the front through the swivel bearing and the
mounting plate.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed