BGS technic 9086 Manuel D'instructions page 8

DISASSAMBLING
Mount the dismantling shells on the wheel bearing housing with two screws.
Hammer the bolts carefully into the mounting plate – the bolts have to be aligned with the wheel
hub's hole circle.
During the disassembly, the bolts press against the mounting shells through the wheel stud holes.
Attach the dismounting plate sideways to the drive shaft and lead the spindle with the attached
mounting plate from the front through the wheel hub and the dismounting plate.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed