Nicols STROB 3000 DMX Notice D'utilisation page 15

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

DMX CONTROL SUMMARY
Intensité: flash intensity can be set from minimum (blackout) to maximum on channel 1 in the 3-
and 4-channel DMX modes. Intensity is maximum in 1-channel DMX mode. The maximum
intensity can be reduced by selecting low power mode as described.
Duration: flash duration can be set from 0 to 650 ms on 50Hz power supply, on channel 2 in the
3- and 4-channel DMX modes. Flash duration is fixed in 1-channel DMX mode
Rate: flash rate can be set from 0 to 17.5flashes per second on 50 Hz power supply, on the
channel 3 in the 3- and 4-channel DMX mode. Flash rate is also controllable in 1- channel DMX
mode.
Built-in effects: 6 programmed effects are available on channel 4 in the 4-channel DMX mode
only. The effect may be altered using the intensity, duration and rate control.
Ramp up = light gradually increases in intensity, then blacks out
Ramp down = light flashes to full intensity, then gradually fades
Ramp up-down = light gradually increases and decreases
Random flash = light flashes randomly with variable rate and intensity. Multiple units flash
independentrly of each other.
Lightning = The flashes simulate lightnings. Duration is not adjustable
Spikes = the lamp remains dimly illuminated between flashes. Set flash intensity, duration, and
rate as normal.
Blind effect = the blinder effect, in which the light remains on for an extended period, is available
in all DMX modes. In the 3- and 4-channel DMX mode - channel 1, the effect is achieved by the
combination of flash duration an rate prevents pauses between flashes. For example, the blinder
effect can be achieved with a flash duration of 0.25 seconds (250 ms) and a flash rate of 4 flashes
per second, or a flash duration of 0.05 seconds (50 ms) and a flash rate of 20 flashes per second.
Single flash = to trigger single flashes, start with the intensity and flash rate at 0 and then set the
intensity on channel 1. When the value of channel 1 is changed, the light will flash once with the
programmed intensity, duration and effect.

Publicité

Table des Matières
loading

Table des Matières