Publicité
Les langues disponibles
Les langues disponibles
WARNING
Risk of collision when making bevel cuts! Collision between saw blade and guide rail.
▶ Set the saw on the guide rail with the correct groove engaging the rib of the rail. The saw blade will
otherwise collide with the guide rail.
1. Secure the guide rail with 2 screw clamps.
2. Set the cutting angle for bevel cuts.
3. Place the saw on the guide rail with the groove marked "1°- 50°" on the rib on the rail.
4. Switch the product on.
5. Advance the saw along the guide rail to make the cut through the workpiece.
6.5
Dust and chips management
You can also operate the product without dust collection method. Make sure that sawdust and chips
can be ejected without obstruction.
7
Care and maintenance
WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance tasks!
Care of the product
•
Carefully remove stubborn dirt.
•
Carefully clean the air vents, if present, with a dry, soft brush.
•
Use only a slightly damp cloth to clean the housing. Do not use cleaning agents containing silicone as
these can attack the plastic parts.
•
Use a dry, clean cloth to clean the contacts of the product.
Care of the Liion batteries
•
Never use a battery with clogged air vents. Clean the air vents carefully using a dry, soft brush.
•
Avoid unnecessary exposure of the battery to dust and dirt. Never expose the battery to high levels of
moisture (e.g. by being dipped in water or left in the rain).
If a battery has been soaked by moisture, treat it as a damaged battery. Isolate it in a non-flammable
container and consult Hilti Service.
•
Keep the battery free of extraneous oil and grease. Do not permit dust or dirt to accumulate unnecessarily
on the battery. Clean the battery with a dry, soft brush or a clean, dry cloth. Do not use cleaning agents
containing silicone as these can attack the plastic parts.
Do not touch the contacts of the battery and do not remove the factory-applied grease from the contacts.
•
Use only a slightly damp cloth to clean the housing. Do not use cleaning agents containing silicone as
these can attack the plastic parts.
Maintenance
•
Check all visible parts and controls for signs of damage at regular intervals and make sure that they all
function correctly.
•
Do not use the product if signs of damage are found or if parts malfunction. Immediately have the product
repaired by Hilti Service.
•
After cleaning and maintenance, install all guards and protective devices and check that they are in full
working order.
To help ensure safe and reliable operation, use only genuine Hilti spare parts and consumables. Spare
parts, consumables and accessories approved by Hilti for use with your product can be found at your
Hilti Store or online at: www.hilti.group
7.1
Cleaning the guard
1. Remove the saw blade.
2. Clean the parts of the guard carefully with a dry brush.
3. Use a suitable tool to remove deposits or cuttings from the inside surfaces of the parts of the guard.
*2276127*
28
27
2276127
English
29
Publicité
