Ribimex PRBAT20 Manuel D'instructions Et D'utilisation page 14

V. OPERATION
5.1- Intended use
This cordless lawnmower is designed for maintaining lawns in private residential gardens. It is
not suitable for artisanal, commercial, professional, or industrial applications.
5.2- Operation
Before use
• Inspect the entire product for damaged, missing, or loose parts, such as screws, nuts, bolts,
caps, ...etc. Tighten securely all fasteners. Do not operate this product until all missing or
damaged parts are replaced.
• Make sure the grass bag is empty and fitted securely.
• Make sure battery pack is sufficiently charged and properly installed in the battery
compartment.
• Inspect the work area before using the tool. Remove any hard objects from the area.
• Only operate the product in daylight or in good artificial light.
• Operate the product only at reasonable hours – not early in the morning or late at night when
people might be disturbed.
Adjusting the cutting height
• WARNING! Make sure the motor is completely
stopped before adjustment.
• The mower has 6 cutting height settings between
25 mm and 75 mm.
• To adjust the height, hold the height adjustment
lever (10) firmly and pull it outward.
• Move the lever to desired position.
• Release the lever in the corresponding notch and
let it engage.
General mowing tips
• The run time of the battery depends on the condition, length, and density of the grass.
• For best performance, always cut off one-third or less of the total height of the grass.
• When cutting long grass, reduce walking speed to allow for more effective cutting and a
proper discharge of the clippings.
• Do not cut wet grass; it will stick to the underside of the deck and prevent proper collection
or discharge of grass clippings.
• New or thick grass may require a higher cutting height.
After use
• Remove the battery packs from the tool.
• Empty the grass bag.
• Clean the tool promptly after use to prevent dust and debris from hardening and becoming
difficult to remove. Refer to Section 6.1 for details.
Position Cutting height (mm)
1
2
3
4
5
6
25
40
50
57
65
75
Page 14 / 27