Install Pet Door - Petsafe PPA19-15791 Manuel D'utilisation

.
STEP 4

Install Pet Door

Fig. 4A
Helpful Tip: Use painters' tape across the Pet Door's interior frame and door to keep
in place while positioning the exterior frame.
Helpful Tip: You should be able to see clearly through all screw holes when your
door is aligned properly.
STEP 5
Insert Screws
Fig. 5A
Before putting away the jigsaw, place the
interior frame (frame with the flap) inside the cut
out and check the fit. Then, place the exterior frame onto
the other side of the door to check the fit. If frames do not
fit inside the opening, you may need to recut to square
opening before proceeding with installation.
Place interior frame with flap inside cut-out of interior door.
Place exterior frame on exterior of door and press firmly
against interior frame and exterior frame with both hands.
Continue to press while moving hands from bottom to top
of frames until alignment tabs connect and both frames are
firmly in place (Fig. 4A).
Thread mounting screws through interior frame and align
with exterior frame. Tighten with screwdriver. DO NOT
OVERTIGHTEN (Fig. 5A).
Helpful Tip: If using an electric screwdriver, set on
low torque.
NOTE: Small SmartDoor
screw placement holes and Large SmartDoor
Pet Door has eight screw placement holes.
www.petsafe.net
Electronic Pet Door has four
™
™
Electronic
13