DIPRA Spid'O JCA-800P2 Mode D'emploi D'origine page 20

Malfunction
The electrical supply does not
correspond to the information given on
the type plate.
The pump stops after a
Pump or intake line are blocked
short time of operation
by solids.
because the thermal
motor protection
Liquid is too viscous.
feature has triggered.
Temperature of liquid or environment
is too high.
Refer to section 2.2.
The pump does not
reach the desired
Worn pump wheel.
pressure.
12. WARRANTY / SPARE PARTS
AND SERVICE
The warranty period begins with the day of the
purchase and is subject to the provisions below :
• Within the period of warranty, all defects which
are to be attributable to defective materials or
manufacturing will be eliminated free of charge.
Any complaints are to be reported immediately
upon their detection.
• The warranty claim becomes void in the case of
interventions undertaken by the purchaser or by
third parties. Damage resulting from improper
handling or operation, incorrect setting-up or
storage, inappropriate connection or installation
or Acts of God or other external influences are
excluded from warranty.
• Parts being subject to wear and tear, such as the
pump wheel (impeller) and mechanical shaft seals
are excluded from warranty. Accessories and
bladder are guaranteed for 6 months.
• All parts were manufactured using maximum
care and high-quality materials and are designed
for a long life-cycle. It should be understood,
however, that the wear and tear depends on the
kind of use, the intensity of use and the internals of
maintenance. Complying with the installation and
maintenance information contained in the present
operating instructions will therefore considerably
contribute to a long life-cycle of these wearing
parts.
• In case of complaints, we reserve the option of
repairing or replacing the defective parts or replace
the entire device. Replaced parts will pass into our
property.
• Claims for liquidated damages are excluded unless
they are caused by wilful acts or negligence on the
side of the manufacturer.
Possible cause
• The warranty does not provide for any claims
beyond those referred to above. The warranty claim
has to be evidenced by the purchaser in the form
of the submission of the sales receipt. The present
warranty commitment is valid in the country in
which the device was purchased.
PLEASE NOTE :
1. Should your device fail to function properly, please
verify first whether an operating error or another
cause is present which cannot be attributed to a
defect of the device.
2. In case you have to take or send in your defective
device for repair, please be sure to enclose the
following documents :
- Sales receipt (sales slip)
- A description of the occurring defect (a description
as accurate as possible will expedite the repair work).
3. In case you have to take or send in your defective
device for repair, please remove any attached parts
which do not belong to the original condition of the
device. If any attached parts of this kind should be
missing upon the return of the device, we shall not
be liable for them.
For a list of available parts, please contact your
dealer.
DIPRA is working to supply main spare parts of this
pump during 5 years, starting from the construction
date of the pump written on the rating label.
In the case of warranty claims or malfunction, please
contact your point of sale. Repair from After Sale
Service during the guarantee does not extend its
initial duration.
Elimination
Please use a device complying with GS
(German technical supervisory authority)
to check the voltage of the lines of the
connection cord (safety information to
be observed!).
Remove possible congestion.
Pump may not be suitable for this liquid.
If feasible, the liquid should be thinned.
Make sure that the temperature of
the liquid being pumped and the
environment do not exceed the max.
admissible values.
Refer to section 2.2.
Please contact the customer service
department.
GB