Kenmore 2800 010 Serie Guide D'utilisation Et D'entretien page 11

WASHER MAINTENANCE
r
WATER iNLET HOSES
Replace inlet hoses after 5 years of use to reduce the risk of
hose failure. Periodically inspect and replace inlet hoses if
bulges, kinks, cuts, wear, or leaks are found.
When replacing your inlet hoses, mark the date of replacement
on the label with a permanent marker.
r
CLEANING YOUR WASHER
Keep your washer as clean and fresh as your clothes. To keep
washer interior odor-free, follow this recommended monthly
cleaning procedure:
l. Make sure the washer is empty.
2. Using liquid chlorine bleach, add 1 cup (250 mL) to liquid
chlorine bleach dispenser.
xJ
iMPORTANT: Do not add detergent to Clean Washer with
bleach cycle. Do not use more than recommended amount of
bleach to avoid damaging product over time.
3. Close washer lid.
4. Press POWER.
5. Select CLEAN WASHER with bleach cycle.
6. Press START/PAUSE/UNLOCK LiD. Water will pour into
washer for a moment and pause, lid will lock, then cycle
will continue.
NOTE: For best results, do not interrupt cycle. If cycle must
be interrupted, press POWER and run a Rinse!Spin cycle to
ensure cleaner or bleach have been rinsed from washer.
To dean exterior:
]. Use a soft, damp cloth or sponge to wipe up any spills.
2. Use all-purpose surface cleaner, if needed.
iMPORTANT: To avoid damaging the washer's finish, do not use
abrasive products.
CLEANING YOUR DISPENSER TRAY
You may find laundry product residue leftover in your dispenser
trays. To remove residue, follow this recommended cleaning
procedure:
1. Pull tray out until you feet resistance.
2. Lift up slightly, and then continue pulling out.
3. Wash in warm, soapy watert using a mild detergent.
4. Rinse with warm water.
5. Air dry, or dry with a towel, then place back into slot.
iMPORTANT: Dispenser trays are not dishwasher safe.
f NON-USE AND VACATION CARE
Operate your washer only when you are home. If moving, or
not using your washer for a period of time, follow these steps:
1. Unplug or disconnect power to washer.
2. Turn off water supply to washer° to avoid flooding due to
water pressure surge.
r
WINTER STORAGE CARE
iMPORTANT: To avoid damage, install and store washer where
it wJJl not freeze. Because some water may stay
in hoses, freezing can damage washer (steam models only). If
storing or moving during freezing weather° winterize your washer.
To winterize washer:
1. Shut off both water faucets, disconnect and drain water
inlet hoses.
2. Put I qt. (1 L) of R.V.-fype antifreeze in basket and run
washer on Rinse/Spin cycte for about 30 seconds
to mix antifreeze and remaining water.
3. Unplug washer or disconnect power.
(" TRANSPORTING YOUR WASHER
1. Shut off both water faucets. Disconnect and drain water
inlet hoses.
2. ff washer witl be moved during freezing weather t follow
Winter Storage Care directions before moving.
3. Disconnect drain from drain system and drain any
remaining water into a pan or bucket. Disconnect drain
hose from back of washer.
4.
5.
6.
7.
Unplug power cord.
Place inlet hoses and drain hose inside washer basket.
Drape power cord over edge and into washer basket.
Place packing tray from original shipping materials back
inside washer, mfyou do not have packing tray, place heavy
blankets or towels into basket opening. Close lid and place
tape over lid and down front of washer. Keep lid taped
11