Tineco FLOOR ONE S3 Serie Mode D'emploi page 20

Brush Roller Self-cleaning
Brush Roller Cover
Grab the front handle while pressing the button
and pull upward to remove.
②
When replacing, always latch the brush cover into
place to avoid leakage.
1. Place the appliance on the charging base after use, the
sensor will auto-detect the level of dirt.
2. When you hear the voice prompt "please begin self-
cleaning cycle," press the self-cleaning button and
begin the process.
3. Once complete, you will hear the voice prompt "self-
cleaning completed, please clean the Dirty Water
Tank." At this point, the appliance will begin charging.
Note:
• Ensure the charging base is plugged in.
• Before self-cleaning cycle, please clean the DWT and
ensure the water level in the CWT exceeds 40%.
①
18
Rinse with water.