Napoleon NEFLC32H-IOT Manuel D'installation Et D'utilisation page 31

Ember bed is Brightness not selected.
not glowing or
Ember LED issue.
dimming.
Main PCB board issue.
LED flashing Appliance has overheated
"OH". and safety thermal switch has
tripped.
Appliance detected power
surge/short power outage has
occurred.
See "operation" section.
Inspect the ember bed LEDs and replace, if necessary.
Inspect the main PCB board and replace, if necessary.
The buzzer emits a warning sound BI one time, the nixie tube
flashes "OH," all functions and buttons are invalid, and all
buttons are off. If the button is pressed, an alarm is issued.
Unplug power or turn off the circuit breaker. Allow appliance
to cool for 15 minutes, then plug in the appliance or turn the
breaker on. If problem persists, consults your dealer.
troubleshooting
W415-2960 / B / 06.07.22
EN
31