KitchenAid KES6403 Guide Des Produits page 17

5.
Phase 4: Place the container (~ 17 oz) on the Drip Tray below Group Head. Then, press
" " button. Clean "
phase is complete. Empty the container. Press "
Machine will go back into heating mode.
WINTER STORAGE CARE
IMPORTANT: To avoid damage, use and store your Espresso Machine where it will not freeze.
Because some water remains inside the unit, freezing can damage the product. If storing or
moving during freezing weather, purge your Espresso Machine.
To purge the Espresso Machine, ensure Steam Wand is attached and Water Tank is at least
half full.
1.
Place a cup under the Steam Wand nozzle.
Turn the Espresso Machine "on (I)", toggle the Mode Button to Steam. Press "
2.
button. Once steam exits the Steam Wand for approximately 10 seconds, remove Water
Tank and allow remaining water in the machine to exit through the Steam Wand.
3.
Purging cycle will be complete once Espresso Machine stops and the Water mode will
blink.
4.
Turn the Main Power on/off (I/O) button to off. Empty and re-install Water Tank. Then,
unplug the Espresso Machine.
TROUBLESHOOTING
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or
electrical shock.
PROBLEM
Espresso Machine will not
start
" light and " " button light will blink fast after the fourth and final
1 2
WARNING
Electrical Shock Hazard
Check if the Espresso Machine is securely plugged into a
grounded 3 prong outlet.
Check to see if the Main power on/off switch is turned on.
" button to complete the Clean Cycle.
SOLUTION
"
17