Philips HQ444/33 Mode D'emploi page 5

Every two months: shaving heads
1 Switch the shaver off, remove the mains
plug from the wall socket and pull the
appliance plug out of the shaver.
C
2 Press the release button (1) and remove
the shaving unit (2).
C
3 Remove the retaining frame by pushing the
sides of the central spring towards each
other (1) and lifting the retaining frame out
of the shaving unit (2).
C
4 Slide the shaving heads out of the retaining
frame and clean them one by one.
Do not mix up the cutters and the guards.
This is essential since each cutter has been
ground with its corresponding guard for optimal
performance. If you accidentally mix the sets up, it
could take several weeks before optimal shaving
performance is restored.
C
5 Clean the cutter with the short-bristled
side of the brush.
Brush carefully in the direction of the arrow.
C
6 Brush the guard.
ENGLISH
7