Publicité
Mount the TC 504 controller
Mounting the controller on the wall
Choose a safe and easily accessible position on a wall next to the kiln. First screw
the two knurled screws into the holes indicated on the back of the control unit. They
will be used later to fasten the controller in the fixing device.
Mount the holding bar of the TC 504 control unit using the 3 dowels and 3 screws,
with one fixing hole pointing upwards and the other
two pointing downwards.
Make sure that the transparent protective foil is cor-
rectly aligned!
The control unit can now be plugged into the fixing
device from above. You might have to loosen the
knurled screws on the controller.
Mounting the controller on the KE controller panel
Place the frontloader panel in a position that will allow the star-shaped knob to be
turned until it locks into the position indicated. When the panel is fixed, you can start
mounting the controller on the panel.
Mount the holding bar of the TC 504 control unit using the 3 screws, nuts and
washers, with one fixing hole pointing upwards and the other two pointing down-
wards.
Make sure that the transparent protective foil is correctly aligned!
First screw the two knurled screws into the holes indicated on the back of the
control unit.
The control unit can now be plugged into the fixing device from above. You might
have to loosen the knurled screws on the controller.
20
Publicité
