Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
1
Remove the 2 screws from the plate on the right side of the
hood to gain access to the junction box.
2
Remove the screw holding the junction box.
3
Remove the pre-cutting inside the junction box. Temporarily
close the hood cover.
4
Determine according to the air outlet, the transition to install.
Place the hood upside down to install the transition with two 3.5 x
9.5 mm screws for the 6" transition or 4 screws for the 8" transition.
6" transition
5
A minimum of 3 people is required. Lift the hood to the ceiling
for installation. NOTE: Exhaust duct and duct connections must be
installed before placing on the ceiling.
6
Place the duct of your domestic installation for the hood air
outlet in the previously installed transition.
7
Pass the connection conduit from your domestic installation
through the pre-cut that was previously removed from the hood
junction box.
8
Once the ductwork is installed lift the hood to attach it to the
ceiling, push until the retaining clips click above the ceiling.
9
To adjust the hood, two people should push up on the hood
and another person should turn the adjusting screws (ECEX40SS: 4
screws, ECEX60SS: 8 screws) with a 3/16" allen wrench, clockwise
until it is tight to the ceiling.
10 General electrical supply VAC of the hood:
•
Connect the black wire from the hood to the black wire from
the wiring in the installation area. (L)
8" transition
•
Connect the 2 white wires from the hood to the white wire of
the installation area (N).
•
Connect the green/yellow wire from the hood to the ground wire
of the installation area. (
11 Once the electrical connection has been made, replace the
junction box cover, and reinstall the plate covering the junction box.
9
Clic!
Clic!
B
A
D
C
)
N
L
N
N
N
L
L
Publicité
