Publicité
Les langues disponibles
Les langues disponibles
7.
If the power supply cable is damaged, it must be substituted by the manufacturer or by its
technical assistance service or however by a person with similar
risks. No liability whatsoever can be accepted if the above instructions in not complied with.
In order to prevent any risks if the the compressor supplied is damaged, these must be replaced
8.
by qualified technician.Installation must be carried out only by qualified technicians according to the
regulation in force. No liability whatsoever can be accepted if the above instructions in not complied with.
WARNING
Any operation of ordinary and extraordinary maintenance of the equipment must be done disconnec-
ting the electric power supply. This maintenance must be done by qualified technician.
The plug has to be always connected to a fixed outlet. It is strictly forbidden to connect the equipment
plug to an extension cord or an adapter.
2.2 START UP AND USE
WARNING
Before to proceed to the switch-ON of the equipment you have to verify as follow:
•
the equipment fitted with built-in condenser must be transported solely in vertical position,
if it is tilted, make sure to wait at least 8 hours before starting the unit; this time will allow the oil on the
compressor to flow into all of its components, lubricating all parts once again.
In order to adjust operating parameters consult the information on the electrical control
•
board section in the user instructions enclosed herein.
•
for equipment with built-in units make sure that the disconnecting switch is open, in position 0, OFF, before
connecting the plug into the power socket, then connect the plug and close the switch.
•
avoid setting temperatures lower than the table unit's relative temperature.
•
the first start-up operation for equipments or for remote units must be performed by qua-
lified staff.
Once the power line is connected to the refrigerated display cabient (see previous paragraph), power the unit
by closing the switch.
After having checked as above, it is possible to start the equipment, giving electricity from the general power
pack. Press green button in position 1, ON.
WARNING
Before loading the food on the equipments, wait that the temperature needed is the same on the
control panel. Avoid to set a lower temperature than that suggested according to the category the
equipment belong to in order to avoid evaporator block.
To regulate functioning parameters please follow the instruction attached to the present manual
"6 PANNELLI COMANDO" Pag. 16.
EVO - EVOK | User and Maintenance Manual | EN
qualifications, so as to avoid all
31
Publicité
