Bosch 3 611 J23 0 Notice Originale page 23

Smartphone status Meaning/cause
indicator (21)
white Important information available (e.g. temper-
ature warning)
Selecting the working mode
Press the (20) button for selecting the working mode re-
peatedly until the working mode you require lights up.
Working mode (22) indic- Functions
ator
In Auto working mode, the power tool reaches maximum performance.
lights up
– 100 % of the maximum speed
– Rapid Shut-off (KickBack Control)
In Favorite working mode, the power tool can be individually configured via a smartphone
lights up
app.
– The speed can be configured in several settings for different applications:
Practical Advice
The power tool with built-in Bluetooth
u
Module is equipped with a radio interface. Local oper-
ating restrictions, e.g. in aircraft or hospitals, must be
observed.
In areas in which the Bluetooth® wireless technology
u
must not be used, the Bluetooth® Low Energy Module
must be switched off via the app.
Setting the drilling depth (see figure E)
You can use the depth stop (14) to set the required drilling
depth X.
– Press the button for depth stop adjustment (5) and insert
the depth stop into the auxiliary handle (13).
The fluting on the depth stop (14) must face downwards.
– Insert the SDS-plus application tool into the SDS-plus tool
holder (2) to the stop. Otherwise, the movability of the
SDS-plus drilling tool can lead to incorrect adjustment of
the drilling depth.
– Pull the depth stop far enough out that the distance
between the drill bit tip and the edge of the depth stop
corresponds to the required drilling depth X.
Overload clutch
If the application tool jams or snags, the power trans-
u
mission to the drill spindle will be interrupted. Always
hold the power tool firmly with both hands to with-
stand the forces this may create and adopt a position
with stable footing.
Switch the power tool off immediately and remove the
u
application tool if the power tool becomes blocked.
Switching on when the drilling tool is blocked may
cause high torque reactions.
Bosch Power Tools
Note: In Favorite working mode, the functions are con-
figured via the smartphone app, while the functions are pre-
set in Auto working mode.
low/medium/high (100 % of the maximum speed) speed
Rapid shut-off (KickBack Control)
®
Low Energy
– To switch the tool back on, release the on/off switch (9)
Inserting screwdriver bits (see figure F)
u
A universal holder (24) with SDS-plus shank (accessory) is
required to work with screwdriver bits.
– Clean and lightly grease the insertion end of the shank.
– Insert the universal holder into the tool holder while turn-
– Check that it is locked by pulling the universal holder.
– Insert a screwdriver bit in the universal holder. Only use
– To remove the universal holder, slide the locking sleeve
Solution
Read the message on the smartphone
The rapid shut-off function (KickBack
Control) gives the user greater control
over the power tool and offers them bet-
ter protection than power tools that do
not have KickBack Control. If the power
tool suddenly and unforeseeably rotates
around the drilling axis, it will switch off
and the rapid shut-off indicator (19) will
light up and the worklight (12) will flash.
When rapid shut-off is activated, the
status indicator (17) flashes red.
and then press it again.
Only apply the power tool to the screw/nut when the
tool is switched off. Rotating tool inserts can slip off.
ing it until it locks automatically.
screwdriver bits that fit the screw head.
(4) backwards and remove the universal holder (24)
from the tool holder.
1 609 92A 6XW | (11.04.2022)
English | 23