Inventum VVW6036AB Manuel D'utilisation page 48

Problem
The appliance stops during a
program.
The appliance makes unusual
sounds during a program.
There is food waste left on the
dishes.
There are white stains on the dishes.
48 • English
Possible cause
The filters are clogged.
The program has not finished.
There is a power failure.
There is a water inlet failure.
The program is paused.
The appliance is not loaded
correctly.
One of the spray arms hits the
dishes.
The appliance is not loaded correctly
and the spray arms cannot reach all
the dishes.
The cutlery basket is too full.
The dishes are placed too close
together.
The amount of detergent is
insufficient.
The selected program is not suitable
for the loaded dishes.
One of the spray arms is clogged.
The filters are clogged.
The filters are not placed correctly.
The water drain pump is clogged.
The amount of detergent is
insufficient.
The level of rinse aid consumption is
set too low.
There is a high level of water
hardness and no salt is used.
Possible solution
Clean the filters. Refer to section
Cleaning the filters
.
Wait until the program is finished.
A buzzer sounds five times when the
program is finished.
Make sure that there is power.
Make sure that there is water inlet
supply.
Start the program.
Make sure that you load the
appliance correctly. Refer to section
Loading the appliance
.
Make sure that you load the
appliance correctly. Refer to section
Loading the appliance
.
Make sure that you load the
appliance correctly. Refer to section
Loading the appliance
.
Make sure that you load the
appliance correctly. Refer to section
Loading the appliance
.
Make sure that you load the
appliance correctly. Refer to section
Loading the appliance
.
Make sure that you fill the detergent
reservoir with a sufficient amount of
detergent. Refer to section
detergent reservoir
.
Choose a suitable program. Refer to
Programs
section .
Clean the spray arms. Refer to
Cleaning the spray arms
section
Clean the filters. Refer to section
Cleaning the filters
.
Make sure that you correctly place
the filters.
Make sure that the water drain pump
is not clogged.
Make sure that you fill the detergent
reservoir with a sufficient amount of
detergent. Refer to section
the filters
.
Adjust the level of rinse aid
consumption. Refer to section
Setting the level of rinse aid
consumption
.
Fill the salt reservoir. Refer to
Filling the salt reservoir
section
Filling the
.
Cleaning
.