Inventum VVW6036AB Manuel D'utilisation page 42

Note:
Contact your local water company to verify the level of water hardness in your area.
Note:
As a default, the level of water hardness of the appliance is set to level H3.
1. Push the on/off button to start the appliance.
2. Push and hold the program selector button for 5 seconds within 1 minute after the appliance starts.
3. Push the program selector button again to change the level of water hardness.
4. Push the on/off button to confirm the setting.
FILLING THE DETERGENT RESERVOIR
Warning:
Store detergent out of reach of children in a cool and dry place.
Caution:
Only use detergent that is suitable for dishwashers.
Caution:
Do not put a detergent tablet in the cutlery basket, only use the detergent reservoir.
Note:
Detergent is available in powder, gel and tablets and is also available as a combined product (with salt
and/or rinse aid). Combined products only produce sufficient results under certain conditions. Observe
the instructions of the packaging.
1. Make sure that you fill the detergent reservoir before you start the appliance.
2. Push the latch (A) to open the detergent reservoir.
3. Fill reservoir (B) with detergent.
Caution:
The detergent reservoir has a capacity of 40 grams. Do not overfill the detergent
reservoir. This can result in poorly dissolving detergent and damage to your
glassware.
4. Close the detergent reservoir.
5. Select a program.
6. Close the door.
FILLING THE RINSE AID RESERVOIR
Rinse aid is used to prevent traces of water droplets on clean dishes and increases drying performance.
Caution:
Only use rinse aid that is suitable for dishwashers.
Note:
Fill the rinse aid reservoir when the rinse aid indicator on the control panel is on.
42 • English
(Figure 11)
(Figure 12)
(Figure 13)