Bose 437308 Mode D'emploi page 5

Low-power Radio-frequency Devices Technical Regulations
Without permission granted by the NCC, any company, enterprise, or user is not allowed to change frequency,
enhance transmitting power or alter original characteristic as well as performance to an approved low power
radio-frequency devices. The low power radio-frequency devices shall not influence aircraft security and
interfere legal communications; If found, the user shall cease operating immediately until no interference is
achieved. The said legal communications means radio communications is operated in compliance with the
Telecommunications Management Act. The low power radio-frequency devices must be susceptible with the
interference from legal communications or ISM radio wave radiated devices.
Product Power State Table
The product, in accordance with the Ecodesign Requirements for Energy Related Products Directive
2009/125/EC and the Ecodesign for Energy-Related Products and Energy Information (Amendment) (EU Exit)
Regulations 2020, is in compliance with the following norm(s) or document(s): Regulation (EC) No. 1275/2008,
as amended by Regulation (EU) No. 801/2013. The product is equipment with HiNA functionality.
Required Power State Information
Power consumption in specified power mode, at
230V/50Hz input
Time after which equipment is automatically
switched into mode
Power consumption in networked standby if all
wired network ports are connected and all wireless
network ports are activated, at 230V/50Hz input
Wireless network port deactivation/activation
procedures. Deactivating all networks will enable
standby mode.
REGU L ATORY AND L EGA L I NFO RM ATIO N
Wi-Fi: To deactivate, insert a thin paperclip into the hole in the back
of the amplifier and press and hold for 2 seconds until the light on the
back of the amplifier blinks white 3 times.
Bluetooth: To deactivate, clear the Bluetooth pairing list. Press and
hold the Bluetooth button l on the amplifier for 10 seconds. To
reactivate, connect a Bluetooth source.
Supplemental Mode: To deactivate and set the amplifier to Main, flip
the ADVANCED SETTINGS switch A to the up position.
Power Modes
Standby
≤ 0.5 W Wi-Fi®, Ethernet, and Bluetooth® ≤ 3.0 W
< 2.5 hours
N/A
|
5 E N G
Networked Standby
≤ 20 minutes
≤ 3.0 W