Publicité
Tourner un peu plus afin d'accentuer légèrement la compression. Faire un quart de tour.
Serrer à 40Nm de couple (Ne pas excéder cette valeur, cela pourrait cause des dommages sur
la moto et le boulon).
•
Mettre le sticker de caoutchouc dans le creux des capuchons de la protection.
•
Mettre les 2 capuchons (Article 1) sur les protections.
Page | 6
Coté droit (assis sur la moto)
•
Enlever le boulon moteur coté droit de la moto (Photo B).
•
Glisser une des rondelles 10mm (Article 4) sur le boulon M10x90mm (Article 3) de façon à ce
que la rondelle se place contre la tête du boulon.
•
Glisser une rondelle de blocage (Article 5) sur le boulon de façon à ce qu'elle se place contre
la rondelle qui vient d'être placée.
•
Glisser ensuite le boulon avec rondelles à travers la protection crash (Article 2) de façon à ce
que la tête du boulon et les rondelles se placent dans le contre alésage de la bobine de
protection.
•
Monter l'ensemble de protection sur le cadre et commencer à serrer le boulon (Photo B).
•
Serrez les boulons jusqu'à ce que vous sentiez une légère compression de l'intérieur de la
protection, à l'aide d'une clé de 17 mm. LA PROTECTION DOIT ETRE POSITIONNEE COMME
EN "C" AVEC LE COTE ARRONDI LE PLUS GROS EN DIRECTION DE L'AVANT DE LA MOTO.
Tourner un peu plus afin d'accentuer légèrement la compression. Faire un quart de tour.
Serrer à 40Nm de couple (Ne pas excéder cette valeur, cela pourrait cause des dommages sur
la moto et le boulon).
•
Mettre le sticker de caoutchouc dans le creux de capuchon de la protection.
•
Mettre les 2 capuchons (Article 1) sur les protections.
The catalogue description and any exhibition of samples are only broad indications of the Products and R&G may make design
changes which do not diminish their performance or visual appeal and supplying them in such state shall conform to the order.
The Buyer acknowledges no representation or warranty (other than as to title) has been given or will apply to the Products other
than those in R&G's order or confirmation and the Buyer confirms it has chosen the Products as being of merchantable quality
and suitable for its particular purposes. Where R&G fits the Products or undertakes other services it shall exercise reasonable
skill and care and rectify any fault free of charge unless the workmanship has been disturbed. The Buyer is responsible for
ensuring that the warranty on the motorcycle is not affected by the fitting of the Products. On return of any defective Products
R&G shall at its option either supply a replacement or refund the purchase money but shall not be liable if the Products have
been modified or used or maintained otherwise than in accordance with R&G's or manufacturer's instructions and good
engineering practice or if the defect arises from accident or neglect. Other than identified above and subject to R&G not limiting
its liability for causing death and personal injury, it shall not be liable for indirect or consequential loss and otherwise its liability
shall be limited to the amounts paid by the Buyer for the Products or the fitting or service concerned. These terms do not affect
the Buyer's statutory droites.
Returns must be pre-authorised (if not pre-authorised the return will be rejected). Goods may only be returned direct to us if they
were purchased direct from us (customer must prove if necessary). Otherwise to be returned to original vendor. Goods must be
in re-sellable condition, in the opinion of R&G Racing. All returns are subject to a 25% restocking and handling fee (25% of the
gross value exc. P&P – at the prevailing price at time of purchase). The customer must pay any and all carriage charges. No
returns of discontinued products, unless within 14 days of purchase. This policy does not affect your statutory droites and does
not refer to faulty goods.
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
C
OUPLES DE SERRAGE GENERAUX
M4 BOULON = 8N
M5 BOULON = 12N
M6 BOULON = 15N
M8 BOULON = 20N
M10 BOULON = 40N
Issue 1 18/10/2013 (NSY)
CONSUMER NOTICE
R&G RACING RETURNS POLICY (NON-FAULTY GOODS)
R&G Racing
www.rg-racing.com
M
M
M
M
M
Email:
info@rg-racing.com
CP0354
Publicité
