Makita BHX2500CA Manuel Utilisateur page 4

Start the Blower only in accordance with the instructions.
Do not use any other methods for starting the engine (6) !
• Use the blower and the tools supplied only for applications
specified.
• Start the blower engine only after the entire tool has been
assembled. Operation of the tool is permitted only after all
the appropriate accessories are attached.
• The engine is to be switched off immediately if there are any engine
problems.
• When working with the blower, always wrap your fingers tightly
around the handle, keeping the control handle cradled between
your thumb and forefinger. Keep your hand in this position to have
your machine under control at all times. Make sure your control
handle (and grip for vacuum attachment) are in good condition and
free of moisture, pitch, oil or grease.
Always ensure a safe, well-balanced footing.
• Operate the blower in such a manner as to avoid inhalation of the
exhaust gases. Never run the engine in enclosed rooms (risk of
suffocation and gas poisoning). Carbon monoxide is an odorless
gas. Always ensure there is adequate ventilation.
• Switch off the engine when resting and when leaving the blower
unattended. Place it in a safe location prevent danger to others,
setting fire to combustible materials, or damage to the machine.
• Never lay the hot blower onto dry grass or onto any combustible
materials.
• All protective parts and guards supplied with the machine must be
used during operation.
• Never operate the engine with a faulty exhaust muffler.
• Shut off the engine during transport (7).
• Position the blower safely during car or truck transportation to avoid
fuel leakage.
• When transporting the blower, ensure that the fuel tank is
completely empty.
Refuelling
• Shut off the engine during refuelling (7), keep well away from open
flame (8) and do not smoke.
• Avoid skin contact with petroleum products. Do not inhale fuel
vapor. Always wear protective gloves during refuelling. Change
and clean protective clothing at regular intervals.
• Take care not to spill either fuel or oil in order to prevent soil
contamination (environmental protection). Clean the blower
immediately after fuel has been spilt. Allow wet cloths to dry
before disposing in properly, covered container to prevent
spontaneous combustion.
• Avoid any fuel contact with your clothing. Change your clothing
immediately if fuel has been spilled on it (fire hazard).
• Inspect the fuel cap at regular intervals making sure that it stays
securely fastened.
• Carefully tighten the locking screw of the fuel tank. Change
locations to start the engine (at least 3 meters away from the place
of refuelling) (9).
• Never refuel in closed rooms. Fuel vapors accumulate at ground
level (risk of explosions)
• Only transport and store fuel in approved containers. Make sure
stored fuel is not accessible to children.
• Do not attempt to refuel a hot or a running engine.
(6)
Resting
●
Transport
●
Refuelling
●
Maintenance
●
Tool Replacement
●
(7)
(8)
(9)
4
4
3 meters