Publicité
Les langues disponibles
Les langues disponibles
plug, have the plug replaced with a suitable model by a qualified professional, who should
ensure that the cord is suitable for the power rating of the appliance (10A). Check that other
appliances with high absorption are not connected to the power line to avoid overloading
and fire hazards. The use of adaptors or extensions is generally not advisable; if it is
necessary to use them, they must comply with safety regulations and the total current (amps)
must not be rated lower than the maximum current of the appliance.
• Before each use, check that the appliance is in good condition and that the power cord is not
damaged: if in doubt consult a qualified professional.
• Ensure that the power cord is correctly positioned and does not come into contact with hot
parts or sharp edges, or become wound around the appliance itself and is not twisted.
• Do not hang or even lean the appliance against any walls.
• Place the fan heater far from any other source of heat, from flammable material (curtains,
tapestries, etc.), from flammable gases or explosive objects (spray cans) and from materials
that can be deformed by heat. Make sure there is 120 cm of free space in front of the fan
heater and 50cm free space on both sides and behind it.
• The surface where the appliance is used must be stable, spacious (do not use on shelves),
level (since the appliance could tip over) and heat resistant.
USING THE APPLIANCE
Gently lift the transparent cover upwards to gain access to the controls.
The appliance comes with a selector switch, thermostat, 24-hour timer, indicator light, tipping
switch, right-left swing function:
- the selector switch (1) controls the following:
"0" = off; "
"= fan on; "1"= hot air (1000W); "2"= very hot air (2000W)
- the thermostat (3) adjusts the ambient temperature, and is greater when the selector is
turned towards the maximum position (clockwise direction): once the temperature has been
reached, it will be kept constant, while setting it to the lines in between causes the element
to come on at intervals.
- The indicator light (4) turns on and off when the appliance reaches the set temperatures.
- Anti-tipping switch inside which allows it to function only when the appliance is vertical,
and switches it off if it tilts.
- Safety device, which turns off the appliance in the event of overheating. To start it again,
remove the plug from the mains and allow it to cool (approximately 10/20 minutes).
- Right-left oscillation: press the oscillation button (1) to allow the appliance to swing from
right to left.
the programmer 24h (5) is used to control "on" and "off" times
-
over a period of 24 hours, and repeat them systematically every
day. The programmer 24h (S) is on when button alongside it is
set to "
" (in the centre), when set to "I" the timer is excluded,
while
in pos."0" the appliance is off.
a) Running the appliance without the timer
a1)
Turn the switch to "1" or "2"; the appliance turns on.
a2)
To turn the appliance off, turn the selector to "0" and remove the plug from the mains.
b) Running the appliance with the timer (button pos
b1)
Set the correct time: turn the timer disc until at the hour of the clock, matching the
correct time to the reference marker.
(button pos. "I").
.
).
13
Publicité
