Publicité
Les langues disponibles
Les langues disponibles
Caution: Ensure the joint spring is not loose, replacing immediately if it is loose.
Thread Cap
The thread cap (28) is replaceable after along usage time or when sign of wear appears.
To remove the thread cap tap to remove the two notch on the retaining ring. Then use a tool
to hold the two holes on the thread cap, turn the thread cap anti-clockwise to remove.
Will need some leverage as Loctite was used on the thread cap during assembly. Replace with
new thread cap and retaining ring if they are worn or damaged. When re-assembling anaero-
bic adhesive should be applied onto the thread of the thread cap (Fig 7).
Worn party
The handpiece should be checked thoroughly after shearing 4000 – 5000 sheep. Any party found to be worn should be re-placed as
this will save costs and enhance the life expectancy of the handpiece.
Handpiece storage
At the end of the season the handpiece should be thoroughly cleaned, examined and any parts found to be worn should be
replaced. Completely grease and oil the handpiece and wrap in newspaper to keep moisture and dust out. Store in a dry place
ready for the next season.
Maintenance
The handpiece is a precision tool and is generally not necessary to disassemble the inner rotating party.
Please follow this instruction when removing, replacing or assembling the handpiece during routine maintenance. The handpiece is
designed to allow easy lubrication and maintenance, so the proper way of lubrication and maintenance is very important to enhance
the life expectancy of the handpiece.
Additional instruction for 18155 Handpiece
As there have been some significant improvements on the 1C model, now you have got the 2C model in hand.
Hereby we would like to draw your attention to the difference between the 1C and 2C model handpiece.
According to the drawing inside the bottom page, the 2C model will not have these parts any more:
27. SF-1 bush; 35. Washer(1); 40.Middle SF bush; 41.Small SF bush(2)
26. Retaining clip has become into retaining ring.
Grease weekly: You need to take the joints assembly off by unscrewing cogs, and then apply a generous amount
of grease into the annular interspaces between the Bush(25) and Thread cap (28).
The grease must be high quality and suit for use at temperature up to 120°.
To keep doing this will be much helpful to the life expectancy of your handpiece.
The thread cap (28) is replaceable after long time using or wearing out. When it re-assembles back, the Loctite-222 (anaerobic
adhesive) should be applied onto the thread.
Declaration of Conformity
Albert KERBL GmbH hereby declares that the product / device described in these instructions complies with the fundamen-
tal requirements and other relevant stipulations of Directives 2006/95/EU, 2004/108/EU and 2006/42/EU . The CE mark
confirms compliance with the Directives of the European Union. The declaration of conformity can be viewed by visiting the following
website: http://www.kerbl.com.
Illustration 7
Publicité
