Publicité
Les langues disponibles
Les langues disponibles
6
Extend Window Filler Panels and attach to top angle rail:
1. Carefully raise window to expose filler panel locking screws on top angle rail. Loosen screws so filler panels slide
easily.
2. Extend panels to fill window opening completely. Tighten locking screws on top (FIG. 16).
3. Close window behind top angle rail.
4. Attach the top angle rail to window frame: Use a 3/32" drill bit to drill one hole through the hole in the middle of top
angle rail into the window frame, and drive one 1/2" HEX-HEAD locking screw through the hole in the middle of top
angle rail into the window frame as shown (FIG. 17).
FIG.16
LOCKING SCREWS
7
Attach Window Filler Panels to Window Frame
1. Extend the window filler panels out against the window frame.
2. Use a 1/8" drill bit to drill a starter hole through the hole in the top leg of each window filler panel and into the window
sash (Fig. 18A and Fig. 18B). Connect with one 1/2" long hex head screw.
C
Window Sash
A. 1/2" long hex head screw
B. left-hand Window Filler
Panel Top Leg
C. Window channel
8
Install Window Sash Seal and Safety Lock
1. Trim window sash seal to fit window width. Insert it into space between upper and lower sashes as shown (FIG. 19).
2. Attach right angle safety lock to top window sash as shown (FIG.20).
3. If necessary, trim weather seals to needed length, peel off protective backing, and use to plug any gaps. See Fig.18B.
FIG.19
Installation Instructions
7/16" Locking Screw
and Washer
FIG. 18A
B
A
WINDOW
SASH SEAL
FIG. 17
FIG. 18B
weather seals
A
A. 1/2" long hex head screw
FIG.20
SAFETY LOCK
1/2" long
HEX-HEAD
SCREW
1/2" long
hex-head
screws
5
Publicité
