Publicité
Les langues disponibles
Les langues disponibles
Insert the
Fig. 9
shredding material
Feeding
funnel
3. Use the paddle to push the material inside if needed.
m
WARNING!
Never put your hands into the hopper while
the wood chipper + shredder is running. Always use the paddle
supplied with your shredder to push items into
the hopper.
4. Only insert as much material as needed to prevent blockage
of the feeding funnel. Chop garden waste that has been
stored for a few days and is wilted and damp alternately
with dry branches. This prevents the cutting blades from
blocking up. Branches with leaves must be completely
chopped before new material is fed. Make sure that the
chopped material can fall freely from the
ejection slot.
5. Keep hold of branches while feeding them into the wood
chipper + shredder until they are automatically drawn in.
6. Keep to the working speed of the wood chipper + shredder
and do not overload it.
7. To protect the wood chipper + shredder from clogging,
shred wilted garden waste that has been left to dry for a few
days and shred thin twigs alternately with branches.
8. Before you shred roots, remove any remaining soil and
stones from them.
9. Do not shred soft, damp material such as kitchen waste;
take it straight to be composted.
10. Keep a few dry branches for the end, as they will help clean
the wood chipper + shredder.
11. Only switch the wood chipper + shredder off after all of the
shredding material has passed through the ejection slot.
Otherwise, the discharge chutes may jam the next time
when the shredder is turned on.
Overload Protection
Your electric wood chipper + shredder is designed with overload
protection. If the shredder is clogged during shredding, the
overload protection will cut the power automatically to protect
your shredder. Wait at least 1 minute before restarting the unit
when the power is cut.
1. To restart the wood chipper + shredder, first press the reset
button (Fig. 10).
Fig. 10
2. Then, push the reverse end of the forward/reverse switch,
and press the On button (Fig. 7). The shredder will push the
jammed branches back from the feeding funnel.
3. After all the jammed branches are pushed out, you can
restart the machine following the instructions in Starting +
Stopping section.
Care + Maintenance
m
ATTENTION!
Before performing any cleaning or
maintenance, disconnect the unit from the power supply.
m
WARNING!
Always wear gloves when cleaning
and maintaining.
Cleaning
1. Always clean the wood chipper + shredder immediately
after use. Use only a warm damp cloth and a soft brush to
clean your wood chipper + shredder.
2. Never spray water on the wood chipper + shredder or wash
it with water. Do not use detergents or solvents as these
could cause irreparable damage to your shredder.
3. Make sure the ventilation slots are always kept clean and
are free of debris.
4. Do not allow stain to become dry and hard on the wood
chipper + shredder surface. This will directly affect the
shredding performance.
9
Reset button
Publicité
