Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting
Problem
Motor does not run
Chipping material is not
being pulled in
Blades cutting
inefficiently
Only a company specialist may be able to correct faults that cannot be rectified with the aid of this table. Please call the
All Season Power customer service center at 1-866-225-9723.
Possible Cause
• Power failure/unit not plugged into a
working receptacle.
• The overload protection has
responded.
• The forward/reverse switch is not
switched on
• The material is jammed in the feeding
funnel.
• The cutting blades are blocked.
• The ejection slot is blocked.
• Counterplate need to be
adjusted or replaced.
Remedy
• Check to make sure unit is plugged into a
working outlet. Make sure extension cord is
not damaged.
• Press the reset button and restart the unit in
reverse mode to remove the jammed material.
Wait one minute before restarting the unit.
• Press the forward end of the forward/reverse
switch.
• Examine the feeding funnel and remove any
blocked material.
• Push the reverse end of the forward/reverse
switch, and press the On button
• Examine the ejection slot and remove any
blocked material.
• Adjust or replace the counterplate.
12
Publicité
