Publicité
Les langues disponibles
Les langues disponibles
Fig. 14
Counterplate
adjusting
knob
4. Separate the cutter shaft from the old cutting blade and
replace with the new cutting blade by sliding it through
(Fig. 15).
Fig. 15
Cutting blade
5. Insert the the cutter shaft with the new cutting blade into
the machine and re-assemble the front cover. After turning
on the machine, slowly turn the counterplate adjusting knob
clockwise until the counterplate and cutting blade are in
contact (Fig. 16).
Fig. 16
Counterplate
adjusting
knob
Storage
Follow the steps below to prepare the electric wood chipper +
shredder for storage:
Cutting
blade
Cutter
shaft
Service + Support
If your Sun Joe
requires service or maintenance, please call the All Season
Power customer service center at 1-866-225-9723.
Model + Serial Numbers
Cutter shaft
When contacting the company or reordering parts, you will need
to provide the model and serial numbers of your product. These
are found on the decal affixed to the housing or handle of your
electric wood chipper + shredder. Copy these numbers into the
space provided below.
11
1. Disconnect the power supply to the wood
chipper + shredder.
2. Clean the wood chipper + shredder with a damp cloth or
hand brush.
3. Inspect the wood chipper + shredder carefully for worn,
loose, or damaged parts. Check connections and screws
and tighten if necessary. Pay special attention to the
counterplate and replace if it shows signs of wear. Refer to
the Care + Maintenance section.
4. Store the wood chipper + shredder indoors in a dry, clean,
and cool area out of the reach of children. Do not store the
unit next to corrosive materials, such as fertilizer and
rock salt.
5. Wipe the extension cord to remove any foreign substances,
such as oil or stains. Replace the extension cord
immediately if it is cut or damaged in any way.
6. Do not cover the wood chipper + shredder with a solid
plastic sheet. Plastic coverings trap moisture around the
shredder, which can damage the unit.
CJ603E electric wood chipper + shredder
®
Record the following numbers from the housing or handle of your
new product:
Model #:
C J 6 0 3 E
Serial #:
Publicité
