Publicité
Les langues disponibles
Les langues disponibles
5. Make sure that the feeding funnel and the ejection slot are
clean and clear of all waste material.
6. Make sure that all nuts, bolts and screws are tight
and secure.
7. Always have any damaged or worn parts repaired, or
replaced by qualified personnel.
Adjusting the Counterplate
During the operation of the unit, the distance between the
blade and the counterplate will become bigger, which will
cause incomplete shredding. To obtain an optimum shredding
result and prevent damage to the blade, the counterplate must
be adjusted at regular intervals. To adjust the counterplate,
follow the instruction below.
1. Stop and unplug the unit.
2. Turn the counterplate adjusting knob clockwise until a
slight friction noise can be heard and some fine aluminum
shavings fall from the ejection slot (Fig. 11).
Fig. 11
Counterplate adjusting
knob
3. Plug on the unit and resume working.
Counterplate Replacement
m
WARNING!
Always wear gloves when cleaning and
maintaining the inside of the unit.
1. Stop and unplug the unit.
2. Open the hopper cover by loosening the 4 screws that
secure it (Fig. 12).
Fine aluminum chips drop
Fig. 12
Loosen the
4 screws
3. The counterplate is located on the left side of the
blade, inserted in a small hole. Simply take out the old
counterplate and replace a new one in the original position
(Fig. 13).
Fig. 13
Counterplate
Cutting blade
4. Replace the hopper cover and secure with the original 4
screws. The electric wood chipper + shredder is ready
for use.
Blade Replacement
m
WARNING!
Always wear gloves when cleaning and
maintaining the inside of the unit.
1. Stop and unplug the unit.
2. Open the hopper cover by loosening the 4 screws that
secure it (Fig. 12).
3. Loosen the counterplate adjustment knob by turning it
counter-clockwise, then remove the cutting blade and cutter
shaft (Fig. 14).
10
Publicité
