Setting The Sleep Timer - LENCO CR-525 Mode D'emploi

Setting the Sleep timer

1. Short press the mode button to select radio or USB (if inserted).
2. Now press the Sleep button repeatedly to set the sleep time (90, 80, 70, 60, 50, 40, 30, 20, 10 min or OFF).
Snooze and Alarm Reset
To use the snooze, press the SNOOZE bar when the alarm is sounding. The alarm will then stop temporarily, and
will be triggered again after 9 minutes. Press the "OFF" button to stop the alarm for 24 hours. (See the section
"Turning off the Alarm" how to disable the alarm.)
USB Charging
Use the USB charging port to charge your smartphone or to power USB powered devices such as a USB type
lamp or fan.
Use a USB cable (not included) to connect your cell phone to the USB connector of the unit. Your cell phone
should start charging.
NOTE: Charging function may not be supported for all phones or electronic devices.
USB music play
Insert USB memory stick into the "USB Playing" port on the right side of the clock. Multi press "Mode" and select
"USB". The music will start/resume play automatically.
Note: The clock will only play MP3 files.
Clock time/memory backup
To keep the current time and radio presets on mains power failure, Insert 2 AA/LR6 batteries (not included) by
opening the Battery compartment (nr 12) and insert the batteries. Check the correct polarity when inserting the
batteries.
SPECIFICATIONS
Frequency Range:
Power Source:
Power Output:
FM 87.5 –108 MHz
AC 230V ~50Hz, 3W
DC 3V (For back-up)
400 mW
8