Kudo _60] Presets - L-Acoustics KUDO Multi-Mode WST Manuel D'utilisation

® ® ® ®
KUDO KUDO KUDO KUDO
multi multi- - - - m m m m ode multi multi
user r r r manual use use use manual manual manual
VERSION 2.0
7.3.3 [KUDO _60] presets
The [KUDO50_60], [KUDO80_60], and [KUDO110_60] presets features a 60 Hz high-pass filter and specific
components equalization to optimize the frequency response of the KUDO
directivity setting is respectively 50°, 80°, or 110°.
!
Always ensure that the K-LOUVER
IMPORTANT
Activate the LOAD PRESET menu from the LA8 amplified controller front panel and then select the desired preset.
Refer to the ''LA8'' user manual for additional instructions. The presets are also accessible using the LA NETWORK
MANAGER software (refer to the ''LA NETWORK MANAGER'' user manual). The accessible parameters in
''HIGH-PASS'' mode are shown in the following chart:
LA8 Inputs / Outputs
IN A
IN B
OUT 1
OUT 2
OUT 3
OUT 4
* IN: input signal. A, B: channel A, B.
Note: Any complimentary subwoofer system should be connected to additional amplified controllers. Please, refer to
the applicable manuals.
KUDO_UM_ML_2-0
® ® ® ®
ode ode wst ode wst wst wst e e e enclosure nclosure nclosure nclosure
®
panels are set in accordance with the selected preset.
Table 3: Accessible parameters in ''HIGH-PASS'' mode
Elements to Preset
connect Assignment*
Input Signal A IN_A
Input Signal B IN_B
Left LF transducer LF_A
Right LF transducer LF_A
MF section MF_A
HF section HF_A
LF: low frequency transducer.
w w w . l - a c o u s t i c s . c o m
®
system whether the K-LOUVER
Accessible (O) and blocked (X) parameters
Mute Gain
X O
X O
O X
O X
O X
O X
MF: medium frequency transducer. HF: high frequency transducer.
®
Delay Polarity
O O
O O
X X
X X
X X
X X
18 en 18 18 18