Kudo _25] And [Kudo _40] Presets - L-Acoustics KUDO Multi-Mode WST Manuel D'utilisation

® ® ® ®
KUDO KUDO KUDO KUDO
multi- - - - m m m m ode multi multi multi
use user r r r manual use use manual manual manual
VERSION 2.0
Figure 8: A 6-KUDO
7.2.3 [KUDO _25] and [KUDO
The [KUDO50_25], [KUDO80_25], and [KUDO110_25] presets feature a 25 Hz high-pass filter resulting in a low
frequency limit of 35 Hz.
The [KUDO50_40], [KUDO80_40], and [KUDO110_40] presets feature a 40 Hz high-pass filter resulting in a low
frequency limit of 40 Hz.
The [KUDO50_ ], [KUDO80_
®
response of the KUDO system whether the K-LOUVER
!
Always ensure that the K-LOUVER
IMPORTANT
Activate the LOAD PRESET menu from the LA8 amplified controller front panel and then select the desired preset.
Refer to the ''LA8'' user manual for additional instructions. The presets are also accessible using the LA NETWORK
MANAGER software (refer to the ''LA NETWORK MANAGER'' user manual). The accessible parameters in ''FULL
RANGE'' mode are shown in the following chart:
LA8 Inputs / Outputs
IN A
IN B
OUT 1
OUT 2
OUT 3
OUT 4
* IN: input signal. A, B: channel A, B. LF: low frequency transducer.
KUDO_UM_ML_2-0
® ® ® ®
ode ode wst ode wst wst wst e e e enclosure nclosure nclosure nclosure
®
vertical line source array connected to two LA8 controllers
_40] presets
], and [KUDO110_
®
panels are set in accordance with the selected preset.
Table 2: Accessible parameters in ''FULL RANGE'' mode
Elements to
connect Assignment*
Input Signal A
Input Signal B
Left LF transducer
Right LF transducer
MF section
HF section
w w w . l - a c o u s t i c s . c o m
IN A
] presets are specifically equalized to optimize the frequency
®
directivity setting is respectively 50°, 80° or 110°.
Accessible (O) and blocked (X) parameters
Preset
Mute Gain
IN_A X
IN_B X
LF_A O
LF_A O
MF_A O
HF_A O
MF: medium frequency transducer. HF: high frequency transducer.
Delay Polarity
O O O
O O O
X X X
X X X
X X X
X X X
16 en 16 16 16