Télécharger Imprimer la page

Kenmore ULTRA WASH 665.1329 Serie Guide D'utilisation Et D'entretien page 10

Masquer les pouces Voir aussi pour ULTRA WASH 665.1329 Serie:

Publicité

Les langues disponibles

Les langues disponibles

FilterRemoval I nstructions
1. Turn
the Upper Filter Assembly 1/4 turn counterclockwise and lift out.
2. Grasp the Lower Filter in the circular opening, lift slightly, and pull forward to remove.
3. Clean the filters as shown below.
tab
To remove
Upper
Filter
Assembly
Cleaning Instructions
IMPORTANT: Do not usewire brush,scouringpad, etc., as they may damage the filters.
Rinse filter under running water until most soils are removed.
If
you have hard-to-remove
soils or calcium
deposits from hard
water, a soft brush may be required.
Filter Reinstallation
Instructions
1. Noting
the previous illustrations,
place the Lower Filter under the Locating
Tabs in the
bottom
of the dishwasher
so the round opening
for the Upper Filter Assembly lines up
with the round opening
in the bottom
of the tub.
_
2. Insert the Upper Filter Assembly
into the circular
opening in the Lower Filter.
_5_
i_
3. Slowly rotate the filter clockwise
until it drops into place. Continue to rotate until the
i_ _'
filter is locked into place. If the filter is not fully seated (still turns freely),
continue to
turn the filter clockwise
until it drops and locks into place.
_
NOTE: The Upper Filter Assembly arrow does not have to align with the arrow in the
Lower Filter as long as the filter is locked.
Locating
tab
To replace
Upper
Filter
Assembly
IMPORTANT:
To avoid damage
to dishwasher, do not operate
your dishwasher
without
the ULTRA WASH ®ÈE filters properly
installed.
Be sure the Lower Filter is securely in place and the Upper Filter Assembly
is locked into place. If the Upper Filter
Assembly turns freely, it is not locked into place.
DISHWASHER EFFICIENCY TIPS
Hot water
dissolves and activates
the dishwasher
detergent.
Hot water
also dissolves grease on dishes and helps glasses dry
spot-free.
For best dishwashing
results, water
should be 120°F (49°C) as it enters the dishwasher.
Loads may not wash as well if
the water temperature
is too low.
Additional
efficiency
tips
To save water, energy
and time, only scrape dishes. Do not rinse dishes before putting
them into the dishwasher.
Use a delay feature
to run your dishwasher
during off-peak
hours. Local utility providers
recommend
avoiding
heavy usage
of energy at certain times of day.
During the summer, run your dishwasher
at night. This reduces daytime
heat buildup
in the kitchen.
Use a rinse aid to improve
drying.
10

Publicité

loading