Télécharger Imprimer la page

Kenmore ULTRA WASH 665.1329 Serie Guide D'utilisation Et D'entretien page 19

Masquer les pouces Voir aussi pour ULTRA WASH 665.1329 Serie:

Publicité

Les langues disponibles

Les langues disponibles

_,_,,_ _,_"_ _j'_:_,y_C__(_,,Oy_'l_O _+
Delay Hours (on some models)
Use this option to run your dishwasher during off-peak
hours. Local utility providers recommend
using
energy during off-peak
hours
when possible.
To delay the start
1. Select a wash cycle and options.
2. Press the delay button.
3. Press START/RESUME.
NOTE: Anytime the door is opened (such as, to add a dish), the START/RESUME button must be pressed again to resume the delay
countdown.
Control Lock Option
Use the Control Lock option to avoid unintended
use of the dishwasher
between
cycles. When LOCK ON is lit, all buttons are
disabled.
The dishwasher
door can still be opened/closed
while the controls are locked.
To turn on the Lock
Press and hold CONTROL
LOCK for 3 seconds. LOCK ON will light up. If you press any pad while your dishwasher
is locked,
the light flashes 3 times and an audible
tone will sound.
NOTE: The dishwasher
cannot start if the control is locked.
To turn off the Lock
Press and hold CONTROL
LOCK for 3 seconds. The light turns off.
Status Indicator
Lights
The status lights on top of control
will inform you if the dishwasher
is sanitized
and/or
complete.
The lights on the control
panel will turn blue while washing
or rinsing, red
while drying, and green when complete.
Selecting
Cycles and Options
1. Select the desired cycle. If you want to run the last cycle that was completed,
you can simply press START once to show
which options you used, then press START again to start the cycle.
2. Select the desired options. Not all options are available
for every cycle. If an invalid option is selected for a given cycle,
the lights will flash.
Turning
OFF/ON
the Sound
Press and hold HIGH TEMP for 3 seconds to toggle
sound ON and OFF. The sound will not be deactivated
for cycle
interruption
or service required
messages.
<Q_"}cel _,}9A C}ice
1. Open the door slightly to stop the cycle. Wait
for the spraying
action to stop before completely
opening
the door.
2.
Press CANCEL/DRAIN
button once. The Cancel/Drain
light will light up.
3. Close the door within 3 seconds. The dishwasher
starts a drain cycle (if water
remains in bottom
of dishwasher).
Let the
dishwasher
drain completely.
The Cancel/Drain
light turns off after 2 minutes.
You can interrupt
a cycle and restart your dishwasher
from the beginning
using the following
procedure.
1. Open the door slightly to stop the cycle. Wait
for the spraying
action to stop, then open the door completely.
2. Check that detergent
dispenser cover is still closed. If cover is open, you will need to refill the detergent
dispenser before
restarting
your new cycle.
3.
Press CANCEL/DRAIN
twice to reset the control.
4. Select new cycles and options.
5.
Press START/RESUME.
19

Publicité

loading