6 - MARKING AND IDENTIFICATION
Model
Features
Year of
construction
7 - MOUNTING OF THE HOSE (Models without hose)
7.2
BP 1"-3/4"
7.2
AP 1"
7.2
AP 3/4"
7.3
Serial
Weight
Number
WARNING! DO NOT PUT HANDS OR
ANY OTHER THING INSIDE THE DRUM!
The hose reels without hose are supplied with the unloaded spring.
Use a hose with dimension and pressure characteristics suitable for use
according to the hose reel model. Especially use hoses for each fluid as
further described below:
Diesel fuel: antistatic hose (R<1 mΩ/m). Pipe without fitting.
Urea / Acqua fredda: Pipe without fitting.
60 bar (3/4")): EN857 1SC hose with fitting F.90° 3/4"G.
60 bar (1"): EN857 1SC hose with fitting F.S.1"G.
7.1)
Fix the hose reel to the bench and remove plastic protection.
7.2)
Models Low Pressure 3/4"-1"(BP): Fix the hose clamp and adjust it
so that during rotation the hose reel is free to turn.
Models High Pressure 1"(AP): connect the hose (A) to the curve,
tightening with the suitable wrench. Tighten the nut (B) on the con-
nection of the drum.
7.3)
Mount the lateral carter and rotate manually the drum in order to
rewind completely the hose.
7.4)
Spring Preload: hold the hose-end and rotate the drum in the opposite
direction for a few laps (see technical manual). During preloading
do not release the hose.
A violent inversion of the rotation could cause damage to ope-
rators and to the spring of the hose reel making the product
unusable.
7.5)
Insert the hose-end between the guide rollers and put the hose rubber
stopper at the desired length.
7.6)
Unwind the hose and rewind it completely, to check if the hose reel
works properly.
7.4
- 10 -
We affix the CE and UKCA
marking as the manufacturer of
this equipment.
On the equipment is securely
attached a tag with curing
adhesive system on which,
in addition to the name of the
manufacturer and the symbols
"CE" and "UKCA", all ne-
cessary information for good
identification of the machine
are indicated (model, duty, year
of construction, weight, etc.).
QR-Code
for manual
7.6