ISE SY-1006 Manuel D'utilisation page 23

4.HOW TO CHECK THE RUNNING MAT FOR PROPER LUBRICATION
1.Disconnect the main power supply.
2.Fold the treadmill up into the storage position.
3.Feel the back surface of the running mat.
If the surface is slick when touched, then no further lubrication is needed.
If the surface is dry to the touch, apply a suitable silicone lubricant.
We recommend you use a silicone based spray to lubricate your Lifespan Treadmill. This Can be
purchased from your local sports Retailer or a local hardware store.
5.BELT ADJUSTMENT
Belt Tension Adjustment-It is very important for joggers and runners in order to provide a
smooth, steady running surface. Adjustment must be made from the right and left rear roller in
order to adjust tension with the Hexagonal Wrench provided in the parts package. The adjustment
bolt is located at the end of the rails as noted in diagram below:
Left bol
Tighten the rear roller only enough to prevent slippage at the front roller. Turn both the right and
left bolt clockwise reasonably and inspect for proper tension. When an adjustment is made to the
belt tension, you must also make a tracking adjustment to compensate for the change in belt
tension.
DO NOT OVERTIGHTEN - Over tightening will cause belt damage and premature bearing failure.
6.BELT TRACKING ADJUSTMENT
This treadmill is designed to keep the belt reasonably centred while in use. It is normal for some
belts to drift near one side while the belt is running with no one on it. After a few minutes of use,
the belt should have a tendency to centre itself. If during use, the belt continues to move toward
one side, adjustments are necessary. The procedures are as below:
▲ First set speed at lowest position.
▲ Second check the belt shifts to which side.
If the belt shifts to right, tighten the right bolt and loosen the left bolt by using Hexagonal
Wrench, until the belt is centered itself; If belt shifts to left, tighten the left bolt and loosen
the right bolt by using 6mm Hexagonal Wrench,until the belt is centered. When adjusting the belt
using the Hexagonal Wrenches, it is important to adjust the belt in half turn incre ments. Over
adjusting the belt can cause damage to the mat.
Note: Adjustment is thru the small hold on the end caps
8
Right bolt
EN