Armlift height
Make an adjustment according to your
cartridge if necessary.
Preparation
Put a record on the turntable.
Remove the stylus cover, taking care not
to damage the stylus, then release the arm
clamp.
Lift the cue lever and move the tone arm over
the record.
1
Check the armlift height (distance
between the stylus tip and record
surface).
If adjustment is needed, go to
step 2 .
The armlift height is factory-adjusted to
8 to 13 mm.
2
Return the tone arm to the arm
rest, clamp it with the arm clamp
and while pressing the armlift
down with your finger, turn the
screw to adjust the height.
Turning the screw clockwise lowers the
armlift.
Turning the screw anti-clockwise raises
the armlift.
Armlift
Allows for LED colour setting, reverse playback
setting, 78 rpm setting, torque setting and brake
setting.
①Turn the unit off and pull out the power plug.
② Adjust as desired by setting the switches with
Allows you to select red or blue for the colour of the
strobe light, speed select buttons, pitch range select
button and RESET LED lamp.
Allows you to disable or enable reverse playback. ( 19)
Allows you to disable or enable 78 rpm. ( 19)
Allows you to select from four levels of strength to
adjust the torque.
High ①
Low ④
Armlift screw
Allows you to select from four levels of brake strength
to stop the turntable after [START-STOP] is pressed.
Arm clamp
High ①
Low ④
Operation settings
a fine Phillips head screwdriver and the like.
ON
ON
OFF
Switch no.
1
2
3
4
5
6
LED colour setting
Switch no.: 1 (LED)
OFF (Factory setting)
Red
Blue
ON
Reverse playback setting
Switch no.: 3 (REV)
OFF (Factory setting)
REV disabled
REV enabled
ON
78 rpm setting
Switch no.: 4 (78)
OFF (Factory setting)
78 rpm disabled
78 rpm enabled
Torque setting
Switch no.: 5 (TQ1)
ON
OFF
②
③ OFF (Factory setting) OFF (Factory setting)
ON
Brake setting
Switch no.: 7 (BK1)
OFF
② OFF (Factory setting) OFF (Factory setting)
ON
③
ON
7
8
ON
Switch no.: 6 (TQ2)
ON
ON
OFF
Switch no.: 8 (BK2)
ON
OFF
ON
17
(17)
English