Technics SL-1200M7B Mode D'emploi page 13

Install the unit on a horizontal surface
protected from vibrations.
Keep this unit as far as possible from speakers.

Adjusting the height to make the
unit horizontal
Increases
the height
Raise the main unit to turn the insulators and
adjust the height.
 Clockwise: Reduces the height.
 Anti-clockwise: Increases the height.
Attention
 Do not turn the insulators too far.
Doing so may cause them to come off or
damage them.
Fit the dust cover
1
While holding the dust cover
from both sides, put it in place by
aligning its four corners with the
four corners of the unit.
 When removing, lift the dust cover
straight up.
Attention
 Return the tone arm to the arm rest and fix
it with the arm clamp before you attach or
detach the dust cover.
 Remove the dust cover while playing.
 Be sure the stylus light (  19) is pressed down
when attaching the dust cover. If the dust
cover is attached with the stylus light raised, it
may touch the dust cover.
Installation

Notes for installation
 Before you move the unit, turn the unit off,
pull out the power plug and disconnect all
connected devices.
 Ensure the unit is not exposed to direct
sunlight, dust, humidity, and heat from a
heating appliance.
 This unit may pick up interference from a
radio if there is one nearby.
Keep the unit as far as possible from a radio.
 Do not install the unit on a heat source.
 Avoid a place with large temperature variations.
 Avoid a place with frequent condensation.
Reduces
 Avoid an unstable place.
the height
 Do not put an object on the unit.
 Do not install the unit in a confined space
such as a book shelf.
 Install the unit at a position well away from
walls or other devices to ensure effective
heat radiation from the inside of the unit.
 Make sure the installation location is
sufficiently strong to withstand the total
weight of the unit and system. (  23)
 Note that the unit may be damaged by
cigarette smoke or moisture from an
ultrasonic humidifier.

Condensation
Think of taking out a cold bottle from a
refrigerator. If you leave it in a room for a while,
dewdrops will form on the bottle surface.
This phenomenon is called "condensation".
 Conditions causing condensation
 Rapid temperature change (caused by
moving from a warm place to a cold place or
vice versa, rapid cooling or heating, or direct
exposure to cooled air)
 High humidity in a room with much steam,
etc.
 Rainy season
 Condensation may damage the unit. If it
has occurred, turn the unit off and leave it
until it adapts to the ambient temperature
(approximately 2 to 3 hours).
13
(13)
English