Maintenance Works
Maintenance contract
To ensure a reliable operation of the appli-
ance maintenance contracts can be con-
cluded with the competent Kärcher sales
office.
Cleaning the protective turbine strainer
Open the cover of the wastewater res-
ervoir.
Squeeze the locking hooks.
Pull off the float.
Turn the protective turbine strainer in a
counter-clockwise direction.
Remove protective turbine strainer.
Rinse dirt off the protective turbine
strainer with water.
Reattach protective turbine strainer.
Attach float.
Replacing the vacuum lips
Remove the vacuum bar.
Unscrew the star grips.
Remove the plastic parts.
Remove the vacuum lips.
Insert new vacuum lips.
Insert the plastic parts.
Screw in and tighten the star grips.
Install D cleaning head
Lift the holder of the cleaning head (see
Chapter "Grey intelligent key/.../clean-
ing head replacement".
Slide the cleaning head under the appli-
ance so that the hose points toward the
rear.
Only slide the cleaning head halfway
under the appliance.
All manuals and user guides at all-guides.com
Remove the lid of the cleaning head.
Connect the power cord of the cleaning
head to the appliance (same colours
must meet).
Replace the lid and lock it.
Slide the cleaning head halfway under
the appliance.
Connect the hose couplers on the
cleaning head to the hose on the appli-
ance.
Insert the tab into the middle of the
cleaning head, between the fork of the
lever.
Align the holder of the cleaning head so
that the drilled holes in the lever and the
cleaning head match.
Insert the stop pin through the bushings
and swivel the locking plate downward.
-
EN
Insert the cylinder pin into the boring of
the drawbar.
Slide the drawbar with the pin the guide
channel on the cleaning head all the
way to the bottom.
Insert the locking plate into the guide
channel and lock it in.
Repeat process on the drawbar on the
opposite side.
Insert the grey intelligent key.
Set brush type "Disc".
Install R cleaning head
Lift the holder of the cleaning head (see
Chapter "Grey intelligent key/.../clean-
ing head replacement".
Slide the cleaning head under the appli-
ance so that the hose points toward the
rear.
Only slide the cleaning head halfway
under the appliance.
Unscrew the star handle and remove
the lid.
Connect the power cord of the cleaning
head to the appliance (same colours
must meet).
Slide the lid in and screw tight.
Slide the cleaning head halfway under
the appliance.
8
23