Publicité
EN - Instruction on mounting and use
APPROVED FOR RESIDENTIAL APPLIANCES
FOR RESIDENTIAL USE ONLY
READ AND SAVE THESE INSTRUCTIONS
PLEASE READ ENTIRE INSTRUCTIONS BEFORE
PROCEEDING.
INSTALLATION MUST COMPLY WITH ALL LOCAL
CODES.
IMPORTANT: Save these Instructions for the Local
Electrical Inspector's use.
INSTALLER: Please leave these Instructions with this unit
for the owner.
OWNER: Please retain these instructions for future
reference.
Safety Warning: Turn off power circuit at service panel
and lock out panel, before wiring this appliance.
Requirement: 120V, 60 Hz, 15 or 20 A Branch Circuit
Removing the packaging
CAUTION!
Remove carton carefully, Wear gloves to protect against
sharp edges.
WARNING!
Remove the protective film covering the product before
putting into operation.
Range Hood EHI670SS
Rated Voltage: 120 V~
Frequency: 60 Hz
Power consumption: 460 W
Current consumption: -
Maximum lamp power: 2x7 W LED
Number: 1 piece.
Made in Italy
Manufactured by: Elica SPA
Imported by : ELICAMEX S.A. de C.V.
Address: Av. La Noria No. 102 int. S/N, Col. Parque Industrial
Querétaro
READ AND SAVE THESE
INSTRUCTIONS
Del. Santiago de Querétaro, C.P. 76215 Querétaro,
R.F.C. ELI060102RK8
Tel. 81 8625 5000 - Cel. 55 3955 8770
Note: The parts marked with the symbol "(*)" are optional
accessories supplied only with some models or otherwise not
supplied, but available for purchase.
Important safety Notice
CAUTION
FOR GENERAL VENTILATING USE ONLY. DO NOT USE
TO EXHAUST HAZARDOUS OR EXPLOSIVE MATERIALS
AND VAPORS.
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR
INJURY TO PERSONS, OBSERVE THE FOLLOWING:
A. Use this unit only in the manner intended by the
manufacturer.
If you have questions, contact the
manufacturer.
B. Before servicing or cleaning the unit, switch power off at
service panel and lock service panel disconnecting
means to prevent power from being switched on
accidentally. When the service disconnecting means
cannot be locked, securely fasten a prominent warning
device, such as a tag, to the service panel.
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR
INJURY TO PERSONS, OBSERVE THE FOLLOWING:
A. Installation Work and Electrical Wiring Must Be Done
By Qualified Person(s) In Accordance With All
Applicable Codes & Standards, Including Fire-rated
Construction.
B. Sufficient air is needed for proper combustion
and exhausting of gases through the flue (Chimney) of
fuel burning equipment to prevent back- drafting.
Follow the heating equipment manufacturers guideline
and safety standards such as those published by the
National Fire Protection Association (NFPA), the
American Society for Heating, Refrigeration and Air
Conditioning Engineers (ASHRAE), and the local code
authorities.
C. When cutting or drilling into wall or ceiling, do
not damage electrical wiring and other hidden utilities.
D. Ducted fans used to exhaust contaminants must always
be vented to the outdoors.
2
Publicité
