Domus HPW-08 Manuel D'utilisation page 37

UNBALANCE ERROR
E9
MAXIMUM UNBALANCE
E10
ERROR
HOT CLOTHES!
E11
UNLOCKING ERROR
E12
WEIGHT MEASURE
ERROR. CALIBRATION
E23
NEEDED
AUXILIARY BOARD
COMMUNICATION
E25
ERROR
MOTOR THERMOSTAT
E26
OPEN
NTC OUT OF RANGE
E27
PRESSURE SENSOR
E28
OUT OF RANGE
Translation of original instructions.
This error is displayed when the washing machine is not able to balance the
clothes.
Try to load the clothes more evenly.
This error is displayed when the washing machine detects too much movement
during the spin cycle.
If this error appears repeatedly, call the technical service. There may be a
problem with the installation and/or shock absorber system.
This error is displayed when the temperature within the tub is higher than 50 ºC
(122 ºF) at the end of the programme.
Wait until the temperature falls below 50 ºC (122 ºF), and the programme will
end automatically.
This error is displayed when the washing machine is not able to unlock the door
at the end of a programme. This error occurs after 3 attempts to unlock the door
every 20 seconds.
Only the option "end" is given. When this is pressed, the machine will try again
and if it is unable to unlock the door, the error will continue to be displayed.
Do not force the door. Call the technical service and they will advise you on how
to open the door safely.
This error is displayed when the washing machine detects an error in the
communication with the weighing device. Call the technical service.
The two options "OK" or "Cancel" are displayed. Press "Cancel" to abort the
programme and return to the selection menu. Press "OK" to continue running the
programme with the nominal weight value of the machine.
This error is displayed when the washing machine detects an error in the
communication with the auxiliary card used in different accessories. Call the
technical service.
The two options "OK" or "Cancel" are displayed. Press "Cancel" to abort the
programme and return to the selection menu. Press "OK" to continue running the
programme, ignoring the corresponding accessory function.
This error is displayed when the temperature detected in the motor is too high.
Call the technical service.
This error is displayed when the temperature detected is out of range. The
temperature sensor is disconnected or damaged. Call the technical service.
Two options "OK" or "Cancel" are displayed. Press "OK" to continue with the
programme, ignoring the heating and press "Cancel" to end the programme.
This error is displayed when the washing machine detects a water level which is
out of range. The pressure sensor is disconnected or damaged. Call the
technical service.
This error will not display any buttons and it is only possible to abort by switching
off the machine.
33