Parkside Performance PRDSP 20-Li C2 Instructions D'utilisation Et Consignes De Sécurité page 55

˜ Attaching the plastic nozzle
pipe
(Fig . K, L)
Connect either end of the plastic nozzle
10 ] [
pipe to the shut-off valve
[ 31 ]
Push the O-ring
[ 29 ]
the union nut towards the thread on the
37 ] [
shut-off valve .
Turn the union nut
direction until it is tight (Fig . G) .
˜ Attaching the nozzle
accessories
The nozzle accessories
only with the plastic nozzle pipe
The nozzle accessories are not to be assembled
with the stainless steel nozzle pipe
Insert the desired nozzle accessory
o
one end of the plastic nozzle pipe
31 ] [
Push the O-ring
o
[ 29 ]
the union nut towards the thread on the
nozzle accessory
Turn the union nut
o
direction to tighten it on the thread of the
nozzle accessory
Choosing the suitable nozzle accessory
Nozzle
Fan nozzle
Double head
nozzle
Single head
nozzle
Mist nozzle
NOTE
u
Only use the nozzles and filters supplied
with the product .
[ 37 ]
.
[ 30 ]
, security ring and
29 ] [
in a clockwise
12 ] [
are to be assembled
[ 10 ]
.
[ 9 ]
.
12 ] [
into
[ 10 ]
.
[ 30 ]
, security ring and
12 ] [
.
[ 29 ]
in a clockwise
[ 12 ]
.
Application
Uniform spray pattern
Spraying large areas
Spraying large crops
High flow rate
Spraying small areas
Spraying large crops
Spraying mist
High flow rate
˜ Mixing the spray solution
m
WARNING!
u
Mix the chemicals strictly in accordance
with the manufacturer's instructions .
Incorrect mixtures may produce toxic
fumes or explosive solutions .
u
Mix only the amount of liquid you need
for the application .
u
Risk of accidental contact of
spray materials with skin and
eyes! Always wear appropriate
personal protection equipment as
instructed by the chemical manufacturer
when using, preparing, handling,
spraying, or disposing of chemicals . This
equipment includes at least goggles,
gloves, respiratory protection and
protective clothing .
Never spray liquid plant control chemicals
undiluted .
Prepare solution and fill the spray tank
outdoors only or in well-ventilated locations .
Mix and fill only in areas where spray spills
can be easily contained .
Have sufficient spare rags available to
adsorb any spills immediately .
Prepare a quantity of solution sufficient only
for the job at hand so that nothing is left
over .
Do not mix different chemicals unless such
mixture is approved by the manufacturer .
Liquids to be sprayed must be as thin as
water . Thicker liquids cannot be sprayed
properly .
Avoid contaminating the environment, the
water supply and/or public sewer systems
with the spraying agent .
Any unused leftovers of spraying agents
must always be collected in a suitable
container and dis-posed of by local or
national regulatory authorities .
[ 3 ]
GB/IE 53