Parkside Performance PRDSP 20-Li C2 Instructions D'utilisation Et Consignes De Sécurité page 49

Check for cracked and deteriorated hoses,
leaks, clogged nozzles, and missing or
damaged parts .
A damaged hose or loose hose connection
can result in accidental contact with the
spray solution, causing serious injury or
property damage .
If damaged, have the product repaired
before use . Many accidents are caused by
poorly maintained products .
Do not lift or carry the product by the hose
or shut-off valve . Carry the product by the
handle and the shoulder strap only .
Never use the product in a room where
there is a danger of explosion or in the
vicinity of flammable liquids or gases .
Do not immerse the product in water or
other liquids . Do not place the product
where it can fall or be pulled into a tub or
sink .
Only operate the product when it is in an
upright position .
Do not operate the product with an empty
spray tank .
It is necessary to provide the appropriate
training in safe operation .
Do not use the product while tired, ill or
under the influence of alcohol, drugs or
medicaments .
Always carry out a visual inspection before
using the product . Do not use the product if
it is damaged . If the product is damaged,
have it checked by qualified personnel .
Always check the product for leaks . If any
are found, correct them before using the
product .
When assembling or removing accessories,
do not point them towards yourself or other
persons .
The product must only be operated by
1 person at a time . Nobody else must be
within a radius of 15 metres at the same
time .
If there is no spray coming out from the
nozzle or the spray amount is decreased,
the hose and spray system may be blocked .
Rinse and clean all parts of the hose and
spray system (shut-off valve, small filter,
nozzle pipe, hose, nozzle) with clean water .
After the product has been stored for a
long time (e .g . during winter), fill the spray
[ 3 ]
tank with clean water . Carry out a test
run to check if there are any leakages or
cracks .
Release the residual pressure in the spray
tank after each use and especially before
removing the spray tank cover . Do so by
pressing the trigger .
Do not modify the product under any
circumstance . Modifications may result in
serious injury .
All servicing and maintenance, other than
the items listed in this instruction manual,
should be performed by an authorised
service centre .
Only use spare parts and accessories
provided by the manufacturer . All other
repairs shall only be carried out by an
authorised service centre . Improper
maintenance, use of non-conforming
components and removal of safety devices
can lead to a hazardous situation, such as
death, life-threatening injuries and damage .
Check the volume application rate during
operation .
˜ Vibration and noise
reduction
To reduce the impact of noise and vibration
emission, limit the time of operation, use
low-vibration and low-noise operating modes
and wear personal protective equipment .
Take the following points into account to
minimise the vibration and noise exposure risks:
Only use the product as intended by its
design and these instructions .
Ensure that the product is in good condition
and well maintained .
Keep tight grip on the handles/grip surface .
GB/IE 47