Parkside Performance PRDSP 20-Li C2 Instructions D'utilisation Et Consignes De Sécurité page 54

NOTE
u
If the connection status LED
light up continuously:
u
Connect the product to the battery
18 ] [
pack . Press the power button
5 seconds . The connection status LED
flashes for a few seconds and then lights
up continuously . The product information
is shown in the {Your
u
Only Smart Performance
rechargeable batteries can be connected
to the PARKSIDE app .
u
Upgrading the firmware can change the
features of the PARKSIDE app .
˜ Before use
˜ Attaching the shoulder strap
(Fig . F)
1 . Clip the strap hooks
6 ] [
strap to the eyelets
3 ] [
tank .
2 . Adjust the length of the shoulder strap
˜ Attaching the stainless steel
nozzle pipe
(Fig . G)
1 . One end of the stainless steel nozzle
[ 9 ]
pipe has an O-ring
side of the stainless-steel nozzle pipe to the
37 ] [
shut-off valve .
2 . Push the union nut
[ 30 ]
ring towards the thread on the shut-off
[ 37 ]
valve .
3 . Turn the union nut
direction until it is tight .
NOTE
u
When the stainless steel nozzle pipe
is not in use: Optional – attach the
stainless steel nozzle pipe to the spray
[ 7 ]
tank pin by the hanging hook
easy carrying .
52 GB/IE
17 ] [
does not
[ 14 ]
for
17 ] [
tools} tab .
[ 6a ]
on the shoulder
[ 27 ]
on the spray
[ 6 ]
31 ] [
. Connect this
29 ] [
and the security
[ 29 ]
in a clockwise
9 ] [
[ 11 ]
for
˜ Adjusting the length of the
stainless steel nozzle pipe
(Fig . H)
NOTE
u
Adjust the length of the stainless steel
nozzle pipe
yourself, bystanders or the environment .
The stainless steel nozzle pipe
telescoped out .
Extending the stainless steel nozzle pipe
1 . Turn the pipe nut
direction until it is loose .
2 . Pull out the stainless steel nozzle pipe
by the tip until it reaches the desired length .
3 . Turn the pipe nut
direction until it is tight .
NOTE
u
To avoid contamination of environment,
operator or bystanders, extend the length
of the stainless steel nozzle pipe
necessary .
.
˜ Adjusting the cone spray
head on the stainless steel
nozzle pipe
(Fig . J)
The cone spray head
stainless steel nozzle pipe
Adjusting the spray pattern
Jet: Turn the tip of the cone spray head
o
in an anti-clockwise direction (loosen the
cone spray head) .
Mist: Turn the tip of the cone spray
o
33 ] [
head in a clockwise direction (tighten
the cone spray head) .
[ 9 ]
to avoid contaminating
9 ] [
can be
32 ] [
in an anti-clockwise
32 ] [
in a clockwise
9 ] [
[ 33 ]
is pre-installed on the
9 ] [
.
9 ] [
:
9 ] [
if
33 ] [