Parkside Performance PRDSP 20-Li C2 Instructions D'utilisation Et Consignes De Sécurité page 46

3 . Keep children and bystanders
away while operating a power
tool. Distractions can cause you to lose
control .
Electrical safety
1 . Power tool plugs must match the
outlet. Never modify the plug in
any way. Do not use any adapter
plugs with earthed (grounded)
power tools. Unmodified plugs and
matching outlets will reduce risk of electric
shock .
2 . Avoid body contact with earthed
or grounded surfaces, such as
pipes, radiators, ranges and
refrigerators. There is an increased risk
of electric shock if your body is earthed or
grounded .
3 . Do not expose power tools to rain
or wet conditions. Water entering a
power tool will increase the risk of electric
shock .
4 . Do not abuse the cord. Never use
the cord for carrying, pulling or
unplugging the power tool. Keep
cord away from heat, oil, sharp edges or
moving parts . Damaged or entangled cords
increase the risk of electric shock .
5 . When operating a power tool
outdoors, use an extension cord
suitable for outdoor use. Use of a
cord suitable for outdoor use reduces the
risk of electric shock .
6 . If operating a power tool in a
damp location is unavoidable, use
a residual current device (RCD)
protected supply. Use of an RCD
reduces the risk of electric shock .
44 GB/IE
Personal safety
1 . Stay alert, watch what you are
doing and use common sense when
operating a power tool. Do not use
a power tool while you are tired
or under the influence of drugs,
alcohol or medication. A moment of
inattention while operating power tools may
result in serious personal injury .
2 . Use personal protective
equipment. Always wear eye protection .
Protective equipment such as dust mask,
non-skid safety shoes, hard hat, or hearing
protection used for appropriate conditions
will reduce personal injuries .
3 . Prevent unintentional starting.
Ensure the switch is in the
off-position before connecting
to power source and/or battery
pack, picking up or carrying the
tool. Carrying power tools with your finger
on the switch or energising power tools that
have the switch on invites accidents .
4 . Remove any adjusting key or
wrench before turning the power
tool on. A wrench or a key left attached
to a rotating part of the power tool may
result in personal injury .
5 . Do not overreach. Keep proper
footing and balance at all times.
This enables better control of the power tool
in unexpected situations .
6 . Dress properly. Do not wear loose
clothing or jewellery. Keep your
hair, clothing and gloves away
from moving parts. Loose clothes,
jewellery or long hair can be caught in
moving parts .
7 . If devices are provided for the
connection of dust extraction
and collection facilities, ensure
these are connected and properly
used. Use of dust collection can reduce
dust-related hazards .