Publicité
Les langues disponibles
Les langues disponibles
Assembly Troubleshooting
TROUBLESHOOTING
Problem
Possible reason
Wires are not properly connected.
Light bulbs are faulty.
Lights do
not work.
Fan is in reverse (blades are moving in
clockwise direction).
Fan does
not seem to
move much
air.
Fan is not properly located.
Screws securing fan blade clips to motor
are loose.
Fan blade and its blade clip are not
fastened securely.
Canopy and mounting bracket are not
Fan wobbles
tightened securely.
or shakes
excessively.
Blades are unbalanced.
ENVIRONMENTAL PROTECTION
Used electrical appliances are recyclable and should not be discarded in your regular
domestic waste! Please actively support us in conserving resources and protecting the
environment by returning this appliance to a collection centre (if available).
Solution
Ensure wire connector in switch
housing is connected.
Unscrew light bulbs and discard
properly. Insert new bulb(s).
Counter-clockwise (forward) is
recommended in warm weather.
Turn off fan and power and wait for
rotation to stop. Change the forward/
reverse slide switch.
Place fan in the centre of the room
so there is at least 12" (30 cm)
between the end of the blades and
walls or other obstructions.
Make sure that screws which attach
fan blade clips to motor are
fastened and tightened.
Tighten screws of fan blade to
blade clip securely.
Ensure that canopy and mounting
bracket are tightened securely to
ceiling joist.
Check by selecting a point on the
ceiling above the tip of one of the
blades. Measure this distance and
ensure all blades are even. If all
blade levels are not equal, adjust
Touching
accordingly (see Balancing Kit
ceiling
Manual).
17
52" Ceiling Fan
Publicité
