for Living 052-9707-2 Mode D'emploi page 11

Step-by-step Guide
STEP 3
Thread the motor wires and safety cable
through the downrod. Insert the
downrod into the collar. Slide hanger pin
through holes of collar and downrod.
Insert and tighten the collar screws. Slide
lock pin into hanger pin until it is locked
into position (Fig. 3).
Warning: Ensure wiring is not pinched or
twisted.
STEP 4
Slide downrod cover, canopy cover and
canopy over the downrod as shown in
Fig. 4.
Step 5.
Carefully reinstall the hanger ball onto
rod being sure that cross pin is in correct
position, set screws are tightened and
wires are not twisted.
3
Hanger pin
4
Hanger Ball
Motor Wires
Hanger pin
5
Cross pin
Hanger Ball
Downrod
Lock pin
Safety cable
Downrod
Canopy
Canopy Cover
Downrod stand cover
collar
Lock Pin
Set Screw
9
52" Ceiling Fan