BorMann PRO BTC3500 Mode D'emploi page 15

EN
Service information
Please note that the following parts of this product are subject to normal or natural wear and that the following parts are therefore also required for use as
consumables.
Wear parts*: Saw blade, carbon brush, table & cutting head guides.
* Not necessarily included in the scope of delivery.
Troubleshooting
Problem
Diamond cutting disc comes off
when motor is deactivated
Motor has no output
The motor switches off during
operation
The pump shuts off
The cutting process is not optimal
Environmental disposal
In order to avoid damages on transportation, the tool has to be delivered in solid packaging. Packaging as well as the unit and accessories are made of
recyclable materials and can be disposed accordingly. The tool's plastics components are marked according to their material, which makes it possible to remove
environmental friendly and differentiated because of available collection facilities.
Only for EU countries
Do not dispose of electric tools together with household waste material!
In observance of European Directive 2002/96/EC on waste electrical and electronic equipment and its implementation in accordance with
national law, electric tools that have reached the end of their life must be collected separately and returned to an environmentally compatible
recycling facility.
15
Possible cause
Fastening nut not tightened properly
1. Cross-section of the extension cable is not
sufficient
2. Overloading
3. The diamond cutting wheel is dull
The motor switches off due to overloading, e.g.
from excessive cutting depth
The pump switches off due to overloading, e.g.
due to heavy contamination
1. The cutting wheel is too heavily stressed
2. Diamond segments are too dull
3. The cutting wheel has overheated due to
insufficient cooling water
WWW.NIKOLAOUTOOLS.GR
Solution
Tighten the fastening nut
1. See electrical connection, the fuse has blown
2. Check the tool
3. Replace the diamond cutting wheel with a new
one
Wait until the motor has cooled down (5-10
minutes), then switch it on again.
Immediately shut down the machine. Clean the
pump and restart the machine after approx. 5-10
minutes. Attention! Never perform dry cuts!
1. Use a suitable cutting wheel, reduce cutting
pressure
2. Sharpen the cutting wheel
3. Optimise the cooling water supply