BorMann PRO BTC3500 Mode D'emploi page 11

EN
• The cut path must be kept of obstacles above and below.
• Make sure that you can remove cut workpieces from the cutting wheel from the side in order to ensure that avoid becoming entangled.
• Use a push rod in order to guide the workpiece safely past the cutting wheel.
• Only work with diamond cutting wheels which are exclusively suitable for wet cutting.
• Use diamond cutting wheels which are the correct size.
• Keep your hands, fingers and arms away from the rotating cutting wheel. Always maintain sufficient clearance from the diamond cutting wheel.
• Replace faulty diamond cutting wheels immediately. Deformed or cracked cutting wheels may not be used.
• Only use diamond cutting wheels recommended by the manufacturer which conform to EN13236. The use of any type of saw blades is prohibited.
• Make sure that a suitable diamond cutting wheel for the material to be cut is selected.
• Do not use the stone cutting machine without safety equipment.
• Always switch off the machine and pull out the mains plug for the correction of errors or removal of jammed workpieces. Only remove the jammed
workpiece after doing so.
• Protect the diamond cutting wheel from impact and jarring. Do not subject it to any lateral pressure.
• Do not stress the device to the extent that it is brought to a stop.
• Wear suitable personal protective equipment (PPE).
- Hearing protection to avoid the risk of becoming hearing impaired.
- Attention! Noise can be harmful to the health. If the permissible noise level of 80 dB(A) is exceeded, hearing protection must be worn.
- Respiratory protection to avoid the risk of inhaling harmful dust.
- Eye protection to avoid the risk of injuring the eyes.
- Gloves are recommended when handling raw materials and shoes with non-slip soles when working outdoors.
• Diamond cutting wheels must always be carried in a container whenever practical.
• This machine may only be operated by persons who are familiar with stone cutting machines.
• Errors in the machine, including all covers and protective devices must be reported to the person responsible for safety as soon as they are discovered.
• Do not leave the device running unattended.
Other safety instructions
Please read all the instructions before using this product!
Workplace
To rule out the risk of physical injury, machine damage, fire and electric shock, please ensure that your workplace is protected:
• against humidity, wetness and rain.
• It is free of Inflammable gases and liquids.
• It is protected from children – use padlocks and the master switch when the machine is not in use.
• It is clean and empty.
• It is well-ventilated and illuminated.
The operators
Healthy common sense and caution are factors that cannot be integrated in a machine. These factors are the responsibility of the operator. Please consider
the following:
• Prevent body contact with grounded surfaces such as pipes and radiators.
• Please be watchful. Do not work at the machine if you are tired.
• Do not operate the product under the influence of alcohol or drugs. Read the warning instructions to determine whether your judgement or your reflexes
could be affected.
• Do not wear loose clothing or ornaments which can get entangled in rotating components. Anti-skid shoes are recommended. Protect long hair with suitable
means.
• Wear eye and hearing protection. Always wear:
- ANSI- approved dust masks.
- Hearing protection.
• Always maintain your balance.
• Do not stretch yourself over running machines.
Residual risks
The machine is built according to the latest technology and the recognized technical safety-related rules. Nevertheless, individual residual risks can occur
during operation.
• Danger of Injury to fingers and hands from the running tool if it is used incorrectly.
• Risk to health from dust. Wear personal protection equipment such as eye protection without fail.
• Injuries due to defective diamond cutting disc. The diamond cutting disc must be checked regularly for physical integrity.
• Risk of injury to fingers and hands during cutting disc replacement. Wear appropriate working gloves.
• Risk of injury during machine activation from sudden start of cutting disc.
11
WWW.NIKOLAOUTOOLS.GR