Grundig TR 3200 BT Mode D'emploi page 43

ALARM­MODE
Interrupting­the­alarm
1
Press any key on the device or »
control while the alarm is sounding.
– Display: 5 minutes
– The alarm (signal tone or radio) stops.
Note:
The alarm will sound again depending on
7
how often a button has been pressed (1 time
= after 5 minutes, 2 times = 10 minutes, 3
times = 15 minutes, 4 times = 30 minutes.
Cancelling­alarm­stand-by
1
To cancel the alarm, press and hold
/MODE« on the device or press »
» 8
remote control.
Activating­ and­ deactivating­ the­
alarm
1 Press » 8 « to switch off the device.
2
Press and hold »ALARM/BACK« to deacti-
vate or reactivate the alarm stand-by.
Note:­
1 time = alarm1 On, 2 times = alarm 1 On
7
and alarm 2 On, 3 times = alarm 1 Off and
alarm 2 On, 4 times = alarm 1 Off and
alarm 2 Off.
­---------------------------------------------------------------------------------------------------------------------
Sleep­Timer
The device has a sleep timer which switches off in
« on remote
radio mode at a preset time. It is possible to adjust
the sleep time between 15 and 60 minutes in 15
minute increments.
Select­the­switch-off­time­for­the­sleep­
timer
1
2­Press and hold »MENU/INFO« on the de-
3
8 « on the
4
Switch­off­the­sleep­timer
1
Press » 8 « to switch on the device.
vice, select Main Menu → Sleep
Alternatively, press »
adjust the sleep time.
Set the switch-off time with »
increments) and confirm by pressing »OK«.
– Display: » « with the remaning time.
Notes:
To check the remaining switch-off time press
7
briefly »Sleep«.
You can set the switch-off time also by press-
7
ing » « (in 15 minutes increments) until the
display shows »Sleep OFF« .
To switch off the sleep timer earlier, press sleep
logo and adjust to »Sleep Timer OFF«
and confirm by press »OK«.
« on remote control to
­ « (in 15 minutes
r e
ENGLISH
43­ ­