Publicité
Les langues disponibles
Les langues disponibles
Start-up and use
The glue applied on the gaskets leaves traces of
!
grease on the glass. Before using the appliance, we
recommend you remove these with a special non-
abrasive cleaning product. During the first few hours
of use there may be a smell of rubber which will
disappear very quickly.
A few seconds after the hob is connected to the
!
electricity supply, a buzzer will sound. The hob may
now be switched on.
- - - - -
+ + + + +
!
If the
or
button is pressed for an extended
period of time, the display scrolls quickly though the
power levels and timer minutes.
Switching on the hob
To switch the hob on, press and hold the
for approximately one second.
Switching on the cooking zones
Each cooking zone is controlled using a selector
button
and a power adjustment device
consisting of a double
• To begin operating a cooking zone, press the
corresponding control button and set the desired
power level (between 0 and 9) using the buttons
- - - - -
+ + + + +
and
.
Booster function*
The booster function for some of the cooking zones
may be used to shorten heating-up times. It may be
activated by pressing the
b b
light directly above the button will illuminate. This
function boosts the power to 2000 W or 3000 W,
depending on the size of the relevant cooking zone.
The booster stops automatically after 4 minutes. While
the booster for one of the cooking zones is active, the
corresponding front or rear cooking zone will operate at
a reduced power level (e.g. if the booster for the rear
left-hand hotplate has been activated, the power level
of the front left-hand hotplate will be reduced). For
further information, please refer to the Technical
description of the models .
Switching off the cooking zones
To switch off a cooking zone, select it using the
corresponding selector button
button
- - - - -
+ + + + +
and
button.
button. The indicator
ooster
and:
- - - - -
• Press the
button: the power of the cooking zone
will progressively decrease until it is switched off.
Programming the cooking duration
! All the cooking zones may be programmed
simultaneously, for a duration between 1 and 99
minutes.
1. Select the cooking zone using the corresponding
selector button.
2. Adjust the power level.
3. Press the
programming button.
light corresponding to the selected zone will start
flashing.
4. Set the cooking duration using the
buttons.
5. Confirm by pressing the
selection occurs after 10 seconds.
The timer begins counting down immediately. A
buzzer sounds for approximately 1 minute and the
cooking zone switches off when the set programme
has finished.
Repeat the above procedure for each hotplate you
wish to programme.
Using multiple programmes and the display
If one or more hotplates are programmed, the
display will show the data for the hotplate with the
least time remaining, and the light corresponding to
the position of the hotplate will flash. The lights
corresponding to the other hotplates programmed
will be switched on.
To visualise the time remaining for the other
programmed hotplates, press the
repeatedly: the time remaining for each hotplate will
be shown sequentially in clockwise order, starting
from the front left hotplate.
Changing the programme
1. Press the
button repeatedly until the duration
you wish to change is shown.
- - - - -
+ + + + +
2. Use the
and
buttons to set the new
duration.
3. Confirm by pressing the
*
Only available in certain models.
GB
The indicator
- - - - -
+ + + + +
and
button or automatic
button
button.
29
Publicité
